Ni/60WC coatings on copper substrate were placed via laser deposition (LD). A structural study was conducted using electron microscopy and a microhardness evaluation. Two body abrasive wear tests were conducted with a pin-on-plate reciprocating technique. A tool steel X12MF GOST 5960 (C-Cr-Mo-V 1.6-12-0.5-0.2) with a hardness of 63 HRC was used as a counterpart. The following results were obtained: Precipitation of the secondary carbides takes place in the thicker layers. Their hardness is lower than that of the primary carbides in the deposition (2425 HV vs. 2757 HV) because they mix with the matrix material. In the thin layers, precipitation is restricted due to a higher cooling rate. For both LD coatings, the carbide’s hardness increases compared to the initial mono-tungsten carbide (WC)-containing powder (2756 HV vs. 2200 HV). Such a high level of microhardness reflects the combined influence of a low level of thermal destruction of carbides during laser deposition and the formation of a boride-strengthening phase from the matrix powder. The thicker layer showed a higher wear resistance; weight loss was 20% lower. The changes in the thickness of the laser deposited Ni-WC coating altered its structure and wear resistance.
15 August 2024 in Вестник Российской академии наук
The article presents the results of the implementation of three strategically important programs for the creation of aircraft gas turbine engines of the new generation PD-14, PD-8 and PD-35 for the purpose of solving the issue of ensuring the technological sovereignty of the Russian Federation in civil aircraft engine manufacturing. Considered are developments which are priority for civil rocket engineering, namely: launch vehicle with a reusable returnable first stage and a fully reusable single-stage launch vehicle for vertical take-off and landing made using multilayer composite materials. Provided are new technologies for implementation by short-pulse laser fusion of ceramic coatings based on boron carbide with microhardness up to 43 GPa and bismuth-alloyed surface layers of steel with unique tribotechnical characteristics: excellent wear resistance and ultra-low dry friction coefficient (up to 0.03). To ensure technological sovereignty in metallurgy, presented are Russian innovative technologies for the repair and production of new mold copper plates of continuous casting machines with wear-resistant composite coatings and recovering of the thickness of copper plates by multipass friction stir lap welding.
Over the past decade, Russian iron & steel works have been making efforts to reduce their environmental impact. The coking industry has traditionally been associated with high levels of air pollution. To reduce emissions, it is important to ensure that the doors of coking chambers are leak-proof over a long period of operation. This study discusses approaches to the design and selection of materials for coke oven doors, as well as the features of their manufacturing and operation. The high level of sealing in the coking chamber is achieved through the use of a modern diaphragm design with a flexible spring-loaded knife-type sealing frame made of heat-resistant stainless steel and a multipoint plunger clamp. The design of the doors allows for gas circulation, which helps to reduce gas pressure at the door and prevents the formation of soot and tar around the knife seal. A long service lifetime is guaranteed by the use of a cast iron body with a vermicular graphite structure. Due to the presence of two systems in the door design, locking and sealing, natural cooling of the door body with air from both sides is achieved. The features of mastering the manufacturing of of leak-proof coke oven doors at the plant in Nizhny Tagil are discussed. It also presents the results of the trial testing and implementation of coke oven doors of a new design at MMK PJSC. A machine vision-based emission control system has been implemented at the coke plant in order to optimize the door maintenance process and monitor any uncontrolled emissions.