The frequency dependence of seismic properties of fully saturated rocks can be related to wave‐induced fluid flows at different scales. The elastic dispersion and attenuation of four fluid‐saturated carbonate rocks, with different microstructures, have been measured over a broad frequency range in the laboratory. The selected rocks were a presalt coquina from offshore Congo, an Urgonian limestone from Provence (France), and an Indiana limestone either intact or thermally cracked. The selected samples present a variety of pore types characteristic of carbonates, and their link with potential squirt flow dispersion was investigated. To cover a broad frequency range, forced oscillations (0.004 to 100 Hz) and ultrasonic (1 MHz) measurement techniques were performed in a triaxial cell, at various differential pressures, on the samples saturated by fluids of different viscosity. Both hydrostatic and axial oscillations were applied in order to get the different dynamic moduli. For all our samples, the drained/undrained transition and the squirt flow mechanisms were characterized experimentally, in terms of amplitude of dispersion, amount of viscoelastic attenuation, and frequency ranges. Biot‐Gassmann's theory was found to apply mainly at seismic frequencies (10–100 Hz). A potential correlation between pore type and possible squirt flow dispersion was investigated. Intragranular microporosity, with either a rimmed or uniform distribution, does not seem to generate any substantial dispersion. On the other hand, cracked intergranular cement and uncemented grain contacts seem to generate substantial squirt flow dispersion, at respectively seismic and sonic log frequencies.
29 December 2017 in Journal of Geophysical Research: Solid Earth
Because measuring the frequency dependence of elastic properties in the laboratory is a technical challenge, not enough experimental data exist to test the existing theories. We report measurements of three fluid‐saturated sandstones over a broad frequency band: Wilkenson, Berea, and Bentheim sandstones. Those sandstones samples, chosen for their variable porosities and mineral content, are saturated by fluids of varying viscosities. The samples elastic response (Young's modulus and Poisson's ratio) and hydraulic response (fluid flow out of the sample) are measured as a function of frequency. Large dispersion and attenuation phenomena are observed over the investigated frequency range. For all samples, the variation at lowest frequency relates to a large fluid flow directly measured out of the rock samples. These are the cause (i.e., fluid flow) and consequence (i.e., dispersion/attenuation) of the transition between drained and undrained regimes. Consistently, the characteristic frequency correlates with permeability for each sandstone. Beyond this frequency, a second variation is observed for all samples, but the rocks behave differently. For Berea sandstone, an onset of dispersion/attenuation is expected from both Young's modulus and Poisson's ratio at highest frequency. For Bentheim and Wilkenson sandstones, however, only Young's modulus shows dispersion/attenuation phenomena. For Wilkenson sandstone, the viscoelastic‐like dispersion/attenuation response is interpreted as squirt flow. For Bentheim sandstone, the second effect does not fully follow such response, which could be due to a lower accuracy in the measured attenuation or to the occurence of another physical effect in this rock sample.
Quantitatively assessing seismic attenuation caused by fluid pressure diffusion (FPD) in partially saturated rocks is challenging because of its sensitivity to the spatial fluid distribution. To address this challenge we performed depressurization experiments to induce the exsolution of carbon dioxide from water in a Berea sandstone sample. In a first set of experiments we used medical X‐ray computed tomography (CT) to characterize the fluid distribution. At an equilibrium pressure of approximately 1 MPa and applying a fluid pressure decline rate of approximately 0.6 MPa per minute, we allowed a change in saturation of less than 1%. The gas was heterogeneously distributed along the length of the sample, with most of the gas exsolving near the sample outlet. In a second set of experiments, at the same pressure and temperature, following a very similar exsolution protocol, we measured the frequency dependent attenuation and modulus dispersion between 0.1 and 1,000 Hz using the forced oscillation method. We observed significant attenuation and dispersion in the extensional and bulk deformation modes, however, not in the shear mode. Lastly, we use the fluid distribution derived from the X‐ray CT as an input for numerical simulations of FPD to compute the attenuation and modulus dispersion. The numerical solutions are in close agreement with the attenuation and modulus dispersion measured in the laboratory. Our approach allows for accurately relating attenuation and dispersion to the fluid distribution, which can be applied to improving the seismic monitoring of the subsurface.