The high content of natural organic matter (NOM) is one of the challenging characteristics of peat water. It is also highly contaminated and contributes to some water-borne diseases. Before being used for potable purposes, peat water must undergo a series of treatments, particularly for NOM removal. This study investigated the effect of coagulation using aluminum sulfate coagulant and adsorption using powdered activated carbon (PAC) as a pretreatment of ultrafiltration (UF) for removal of NOM from actual peat water. After preparation and characterization of polysulfone (Psf)-based membrane, the system’s performance was evaluated using actual peat water, particularly on NOM removal and the UF performances. The coagulation and adsorption tests were done under variable dosings. Results show that pretreatment through coagulation–adsorption successfully removed most of the NOM. As such, the UF fouling propensity of the pretreated peat water was substantially lowered. The optimum aluminum sulfate dosing of 175 mg/L as the first pretreatment stage removed up to 75–78% NOM. Further treatment using the PAC-based adsorption process further increased 92–96% NOM removals at an optimum PAC dosing of 120 mg/L. The final UF-PSf treatment reached NOM removals of 95% with high filtration fluxes of up to 92.4 L/(m2.h). The combination of three treatment stages showed enhanced UF performance thanks to partial pre-removal of NOM that otherwise might cause severe membrane fouling.
9 October 2024 in Leuser Journal of Environmental Studies
The practice of coal mining has been demonstrated to exert a detrimental impact on the surrounding environment, particularly through the formation of acid mine drainage (AMD) ponds, which have the potential to pollute water sources. The reclamation of AMD is necessary to treat wastewater to ensure its safety for discharge into the environment and subsequent use as clean water. This study aims to treat AMD by comparing ultrafiltration (UF) and pervaporation (PV) processes utilizing silica-pectin multichannel membranes. The membranes were fabricated by coating silica-pectin sol on an inner surface of multichannel tubular support. The UF process was conducted under various pressures (1-3 bar), while the PV process was tested at various feed temperatures. Both permeate were collected and analyzed using several parameters (pH, Mn, and conductivity). The results showed that the UF process is more effective in collecting permeate flux over 136.6 L.h-1.m-2 at 3 bar pressure. Meanwhile, PV performs high permeate quality with Mn and conductivity rejection of 99.9 and 96.5%, respectively. Both UF and PV processes exhibit slightly increasing permeate pH with a range of 4.5-5.6. It concluded that multichannel silica-pectin membranes successfully reclamation AMD to enhance water quality. In addition, the UF process is more affordable for recycling AMD with high permeate flux, pretty good Mn, and conductivity rejection of over 95%.