Virginie Roche

Dr. Virginie Roche

Univ. Grenoble Alpes, Univ. Savoie Mont Blanc, CNRS, Grenoble INP, LEPMI, 38000 Grenoble, France

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 January 2023 in Corrosion Science
Verified
Journal Article
Closed access
MDMargarita Diaz-Ramos
Margarita Diaz-Ramos
Virginie RocheVirginie Roche
Virginie Roche
RSRan Song
Ran Song
HFHongtao Fan
Hongtao Fan
CBChristophe Bureau
Christophe Bureau
JLJean Claude Lepretre
Jean Claude Lepretre

5 November 2018 in Materials
Verified
Journal Article
Open access
PDF file
GKGuilherme Koga
Guilherme Koga
LOLucas Otani
Lucas Otani
ASAna M. B. Silva
Ana M. B. Silva
Virginie RocheVirginie Roche
Virginie Roche
RNRicardo Nogueira
Ricardo Nogueira
WBWalter Botta
Walter Botta
The composition of a commercial duplex stainless steel was modified with boron additions (3.5, 4.5, and 5.5 wt.%) and processed by rapid-quenching techniques: Melt-spinning, copper-mold casting, and high-velocity oxygen fuel (HVOF). Spray deposition was also used to produce alloys as the process may induce rapid-solidified-like microstructures. These processing routes led to microstructures with distinguished corrosion resistance. Among the alloys with different boron contents, the 63.5Fe25Cr7Ni4.5B composition enabled the production of fully amorphous ribbons by melt-spinning. The cooling rate experienced during copper-mold casting, high-velocity oxygen fuel, and spray deposition did not ensure complete amorphization. The crystalline phases thereby formed were (Fe,Cr)2B and (Fe,Mo)3B2 borides in an austenitic-matrix with morphology and refinement dependent of the cooling rates. Fully amorphous 63.5Fe25Cr7Ni4.5B ribbons exhibited outstanding corrosion resistance in chloride-rich alkaline and acid media with negligible corrosion current densities of about 10−8 A/cm² and a broad passivation plateau. Although the specimens of the same composition produced by HVOF process and spray deposition exhibited lower corrosion resistance because of intrinsic porosity and crystalline phases, their corrosion behaviors were superior to those of AISI 1045 steel used as substrate with the advantage to be reinforced with hard borides known to be resistant against wear.

8 February 2024 in Corrosion Science
Verified
Journal Article
Closed access
WBWeverson C. Batalha
Weverson C. Batalha
AJAlberto M. Jorge Junior
Alberto M. Jorge Junior
MMMarc Mantel
Marc Mantel
YCYannick Champion
Yannick Champion
Virginie RocheVirginie Roche
Virginie Roche

3 November 2021 in Metals
Verified
Journal Article
Open access
PDF file
Arthur de Bribean GuerraArthur de Bribean Guerra
Arthur de Bribean Guerra
AJAlberto Moreira Jorge
Alberto Moreira Jorge
Virginie RocheVirginie Roche
Virginie Roche
Claudemiro BolfariniClaudemiro Bolfarini
Claudemiro Bolfarini
A metastable beta TMZF alloy was tested by isothermal compression under different conditions of deformation temperature (923 to 1173 K), strain rate (0.172, 1.72, and 17.2 s−1), and a constant strain of 0.8. Stress–strain curves, constitutive constants calculations, and microstructural analysis were performed to understand the alloy’s hot working behavior in regards to the softening and hardening mechanisms operating during deformation. The primary softening mechanism was dynamic recovery, promoting dynamic recrystallization delay during deformation at higher temperatures and low strain rates. Mechanical twinning was an essential deformation mechanism of this alloy, being observed on a nanometric scale. Spinodal decomposition evidence was found to occur during hot deformation. Different models of phenomenological constitutive equations were tested to verify the effectiveness of flow stress prediction. The stress exponent n, derived from the strain-compensated Arrhenius-type constitutive model, presented values that point to the occurrence of internal stress at the beginning of the deformation, related to complex interactions of dislocations and dispersed phases.

6 March 2025 in Electrochimica Acta
Verified
Journal Article
Closed access
ACAna Larissa Soares Cruz
Ana Larissa Soares Cruz
Virginie RocheVirginie Roche
Virginie Roche
MDMargarita Diaz-Ramos
Margarita Diaz-Ramos
GFGustavo Figueira
Gustavo Figueira
WWWitor Wolf
Witor Wolf
GKGuilherme Yuuki Koga
Guilherme Yuuki Koga

11 March 2026 in Corrosion Science
Verified
Journal Article
Closed access
MDMargarita Diaz-Ramos
Margarita Diaz-Ramos
JLJean Claude Leprêtre
Jean Claude Leprêtre
RSRan Song
Ran Song
HFHongtao Fan
Hongtao Fan
Virginie RocheVirginie Roche
Virginie Roche