As a hormone that determinates the level of fruit ripeness, ethylene concentration monitoring plays an important role in the agricultural field. One of the techniques that can be used to detect ethylene concentration is the sensing method. Zinc oxide (ZnO) is a multipurpose metal oxide semiconductor with a wide application in sensing area. Here, we use a ZnO-based flexible sensor to identify the presence of ethylene gas at certain concentrations. The as-synthesized ZnO layers were deposited on a polyethylene terephthalate-indium doped tin oxide (PET-ITO) flexible substrate using a simple electrochemical deposition method. To enhance the performance of the ethylene sensor, a small amount of silver (Ag) was added to the seeding solution. From the study, it was revealed that the ZnO-Ag layers were able to identify the presence of ethylene gas at the lowest concentration of 29 ppm. The most optimal result was obtained using 1 mM Ag. This layer demonstrated a response of 17.2% and 19.6% of ethylene gas at concentrations of 29 and 50 ppm, with recovery times of four and eight minutes, respectively.
1 June 2019 in IOP Conference Series: Materials Science and Engineering
As an emerging n-type semiconductor, ZnO has been widely applied in sensor area. In this study, we prepared an ethylene sensor using ZnO layer on FTO glass substrate. The seed layer was deposited using simple electrodeposition method using voltage of -1.1 V for 2 hours in cold bath (6°C). The ZnO layer was further grown using CBD technique at 90°C for 2 hours. In order to observe the effect of structural manipulation on the sensor performance, some of the ZnO layer samples were undergoing hydrothermal treatment at 100ºC for 1 hour under 1 bar N2 gas. After annealing process, all ZnO layers were exposed with 50 ppm ethylene gas in closed chamber. Based on the results, it is shown that the optimum ZnO layer has been successfully identified the ethylene gas in concentration of 50 ppm, with response value of 2.40% at 200°C.
Capacitive sensor works based on capacitive methods and serves to detect changes in the composition of dielectric materials by determining the capacitance value