Present-day science indicates that developing sensors with excellent sensitivity and selectivity for detecting early signs of diseases is highly desirable. Electrochemical sensors offer a method for detecting diseases that are simpler, faster, and more accurate than conventional laboratory analysis methods. Primarily, exploiting non-noble-metal nanomaterials with excellent conductivity and large surface area is still an area of active research due to its highly sensitive and selective catalysts for electrochemical detection in enzyme-free sensors. In this research, we successfully fabricate Metal-Organic Framework (MOF) FeBDC-derived Fe3O4 for non-enzymatic electrochemical detection of glucose. FeBDC synthesis was carried out using the solvothermal method. FeCl2.4H2O and Benzene-1,4-dicarboxylic acid (H2BDC) are used as precursors to form FeBDC. The materials were further characterized utilizing X-ray Powder Diffraction (XRD), Scanning Electron Microscopy (SEM), and Fourier-Transform Infrared Spectroscopy (FTIR). The resulting MOF yields good crystallinity and micro-rod like morphology. Electrochemical properties were tested using Cyclic Voltammetry (CV) and Differential Pulse Voltammetry (DPV) with a 0.1 M of Phosphate Buffer Saline (PBS pH 7.4) solution as the supporting electrolyte. The measurement results show the reduction and oxidation peaks in the CV curve of FeBDC, as well as Fe3O4. Pyrolysis of FeBDC to Fe3O4 increases the peak of oxidation and reduction currents. The Fe3O4 sample obtained has a sensitivity of 4.67 µA mM−1.cm−2, a linear range between 0.0 to 9.0 mM, and a glucose detection limit of 15.70 µM.
As a hormone that determinates the level of fruit ripeness, ethylene concentration monitoring plays an important role in the agricultural field. One of the techniques that can be used to detect ethylene concentration is the sensing method. Zinc oxide (ZnO) is a multipurpose metal oxide semiconductor with a wide application in sensing area. Here, we use a ZnO-based flexible sensor to identify the presence of ethylene gas at certain concentrations. The as-synthesized ZnO layers were deposited on a polyethylene terephthalate-indium doped tin oxide (PET-ITO) flexible substrate using a simple electrochemical deposition method. To enhance the performance of the ethylene sensor, a small amount of silver (Ag) was added to the seeding solution. From the study, it was revealed that the ZnO-Ag layers were able to identify the presence of ethylene gas at the lowest concentration of 29 ppm. The most optimal result was obtained using 1 mM Ag. This layer demonstrated a response of 17.2% and 19.6% of ethylene gas at concentrations of 29 and 50 ppm, with recovery times of four and eight minutes, respectively.
In this work, a long microrod VSB-5 (denoted as NiP-300 in this article) has been successfully prepared as electrochemical material by the hydrothermal method. Based on scanning electron microscopy images, VSB-5 revealed microrod morphology with a length of about 5 µm and a diameter of about 0.2 µm. Thus, the approximate length-to-diameter was 25, which is more significant than previous reports leading to the enhancement of electrolyte access for the electrochemical application. The electrochemical behavior of VSB-5 was studied by three-electrode setup experiment at different scan rates and current densities. At 0.1 A g−1 of current density, the sample delivered the specific capacitance of 69.05 F g−1.