Wojciech Szkliniarz

Prof. Dr. Wojciech Szkliniarz

Faculty of Materials Engineering, Silesian University of Technology, Katowice, Poland

Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 1995 in Journal of Materials Processing Technology
Verified
Journal Article
Closed access
Wojciech SzkliniarzWojciech Szkliniarz
Wojciech Szkliniarz
GSG. Smołka
G. Smołka

1 October 2009 in Materials Characterization
Verified
Journal Article
Closed access
AKAgnieszka Kościelna
Agnieszka Kościelna
Wojciech SzkliniarzWojciech Szkliniarz
Wojciech Szkliniarz

11 January 2023 in Materials
Verified
Journal Article
Open access
ASAgnieszka Szkliniarz
Agnieszka Szkliniarz
Wojciech SzkliniarzWojciech Szkliniarz
Wojciech Szkliniarz
In a way so far unmatched in any single study, this paper presents the complex characteristics of commercially pure titanium (CP-Ti) containing 0.2 wt.% carbon, which is significantly above the carbon level in commonly used titanium alloys, while at the same time being the maximum permitted content in light of the recommendations in force. It has been demonstrated that the addition of carbon in CP-Ti can have many positive impacts. The investigated Ti-0.2C alloy was produced in a cold-copper crucible induction vacuum furnace and processed into a 12 mm diameter bar by hot rolling. The structure and properties of the Ti-0.2C alloy were compared to those of an CP-Ti Grade 1 produced and processed under the same technical conditions. The addition of 0.2 wt.% carbon to CP-Ti has been found to change the course of the crystallization process, the course and temperatures of phase transformations, and the values of lattice parameters; reduce susceptibility to grain growth; and create the possibility for additional hardening during solution treatment and aging. At the same time, it results in an assumed improvement in properties by increasing the tensile strength and yield strength, hardness, creep and oxidation resistance, and abrasive wear. It has a negative effect but is still within the acceptable range on impact strength and susceptibility to hot and cold deformation.

1 August 2003 in Materials Chemistry and Physics
Verified
Journal Article
Closed access
JCJ. Chrapoński
J. Chrapoński
Wojciech SzkliniarzWojciech Szkliniarz
Wojciech Szkliniarz
AKA. Kościelna
A. Kościelna
BSB. Serek
B. Serek

1 February 2001 in Materials Characterization
Verified
Journal Article
Closed access
JCJacek Chrapoński
Jacek Chrapoński
Wojciech SzkliniarzWojciech Szkliniarz
Wojciech Szkliniarz

1 September 2015 in Surface and Coatings Technology
Verified
Journal Article
Closed access
ASAgnieszka Szkliniarz
Agnieszka Szkliniarz
GMGrzegorz Moskal
Grzegorz Moskal
Wojciech SzkliniarzWojciech Szkliniarz
Wojciech Szkliniarz
RSRadoslaw Swadzba
Radoslaw Swadzba