Jeong-Yeol Choi

Prof. Jeong-Yeol Choi

Department of Aerospace Engineering, Pusan National University, Busan, Korea
orcid

Research Focus & Metrics

Academic Career Length

30Years (1997-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2005 in Proceedings of the Combustion Institute
Verified
Journal Article
Closed access
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi
FMFuhua Ma
Fuhua Ma
VYVigor Yang
Vigor Yang

24 September 2022 in Proceedings of the Combustion Institute
Verified
Journal Article
Closed access
SJSeung-Min Jeong
Seung-Min Jeong
JLJae-Hyuk Lee
Jae-Hyuk Lee
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi

1 January 2019 in Proceedings of the Combustion Institute
Verified
Journal Article
Closed access
PPPradeep Kumar Pavalavanni
Pradeep Kumar Pavalavanni
Chae Hoon SohnChae Hoon Sohn
Chae Hoon Sohn
BLBok Jik Lee
Bok Jik Lee
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi

13 January 2021 in Energies
Verified
Journal Article
Open access
PDF file
WHWon-Sub Hwang
Won-Sub Hwang
BSBu-Kyeng Sung
Bu-Kyeng Sung
WHWoojoo Han
Woojoo Han
KHKang Y. Huh
Kang Y. Huh
BLBok Jik Lee
Bok Jik Lee
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi
A large eddy simulation (LES) and combustion instability analysis are performed using OpenFOAM for the multiple shear-coaxial injector combustor DLR-BKD (in German Deutsches Zentrum für Luft–Brennkammer D, German Aerospace Center–Combustion Chamber D), which is a laboratory-scale combustor operating in a real-gas environment. The Redlich–Kwong–Peng–Robinson equation of state and steady-laminar flamelet model are adopted in the simulation to accurately capture the real-gas combustion effects. Moreover, the stable combustion under the LP4 condition is numerically analyzed, and the characteristics of the combustion flow field are investigated. In the numerical simulation of the combustion instability, the instability is generated by artificially superimposing the 1st transverse standing wave solution on the stable combustion solution. To decompose the combustion instability mode, the dynamic mode decomposition method is applied. Several combustion instability modes are qualitatively and quantitatively identified through contour plots and graphs, and the sustenance process of the limit cycle is investigated.

3 March 2021 in Energies
Verified
Journal Article
Open access
PDF file
HHHyung-Seok Han
Hyung-Seok Han
ELEun Sung Lee
Eun Sung Lee
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi
A small rotating detonation engine (RDE) model and the corresponding experimental setup were constructed for the experimental investigation of the detonation propagation characteristics and thrust performance of a circular RDE. Experiments were conducted at a range of 0.3–2.5 equivalence ratio with a total mass flow rate of less than 180.0 g/s using a C2H4/O2 mixture. Irregularly unstable detonative combustion occurs immediately after the detonation initiation, which includes initiation, propagation, decaying, and the merging of detonation waves. Following this, periodically unsteady detonative combustion occurs in the circular channel, resulting in the stable operation of the RDE. During stable operation, two detonation waves are predominant, rotating along the wall at a speed lower than the Chapman–Jouguet (CJ) detonation speed. The characteristic velocity efficiency is approximately 73% on average. The low characteristic velocity efficiency is presumed to be caused by the unoptimized combustion channel and the poor mixing efficiency owing to the two-dimensional injector configuration. The effect of the RDE component design and the RDE flow field characteristics need to be further investigated for improving the performance of the RDE.

15 March 2015 in Journal of Mechanical Science and Technology
Verified
Journal Article
Closed access
PDF file
PKP. Pradeep Kumar
P. Pradeep Kumar
KKKui-Soon Kim
Kui-Soon Kim
SOSejong Oh
Sejong Oh
Jeong-Yeol ChoiJeong-Yeol Choi
Jeong-Yeol Choi