In this paper, a prototype complementary metal-oxide-semiconductor (CMOS) image sensor with a 2.8-μm backside-illuminated (BSI) pixel with a lateral overflow integration capacitor (LOFIC) architecture is presented. The pixel was capable of a high conversion gain readout with 160 μV/e− for low light signals while a large full-well capacity of 120 ke− was obtained for high light signals. The combination of LOFIC and the BSI technology allowed for high optical performance without degradation caused by extra devices for the LOFIC structure. The sensor realized a 70% peak quantum efficiency with a normal (no anti-reflection coating) cover glass and a 91% angular response at ±20° incident light. This 2.8-μm pixel is potentially capable of higher than 100 dB dynamic range imaging in a pure single exposure operation.
A backside-illuminated complementary metal-oxide-semiconductor (CMOS) image sensor with 4.0 μm voltage domain global shutter (GS) pixels has been fabricated in a 45 nm/65 nm stacked CMOS process as a proof-of-concept vehicle. The pixel components for the photon-to-voltage conversion are formed on the top substrate (the first layer). Each voltage signal from the first layer pixel is stored in the sample-and-hold capacitors on the bottom substrate (the second layer) via micro-bump interconnection to achieve a voltage domain GS function. The two sets of voltage domain storage capacitor per pixel enable a multiple gain readout to realize single exposure high dynamic range (SEHDR) in the GS operation. As a result, an 80dB SEHDR GS operation without rolling shutter distortions and motion artifacts has been achieved. Additionally, less than −140dB parasitic light sensitivity, small noise floor, high sensitivity and good angular response have been achieved.
In this paper, the light intensity and charge holding time dependence of pinned photodiode (PD) full well capacity (FWC) are studied for our pixel structure with a buried overflow path under the transfer gate. The formulae for PDFWC derived from a simple analytical model show that the relation between light intensity and PDFWC is logarithmic because PDFWC is determined by the balance between the photo-generated current and overflow current under the bright condition. Furthermore, with using pulsed light before a charge holding operation in PD, the accumulated charges in PD decrease with the holding time due to the overflow current, and finally, it reaches equilibrium PDFWC. The analytical model has been successfully validated by the technology computer-aided design (TCAD) device simulation and actual device measurement.
We propose and demonstrate a low-random-noise (RN) design for pixel-parallel single-slope ADCs (SS-ADCs), achieving 2.2 e-rms in a 3.24 µm pixel. In this paper, we discuss AC-based RN estimation with respect to the comparator bias current and a bandwidth-limiting capacitor in digital-pixel sensors (DPSs). RN is composed of thermal noise (TN) and flicker noise (FN), where FN can be a major contributor in DPSs because of its area limitation. We express the concise equation to estimate the FN/TN ratio, in which the FN characteristic is modulated by the correlated double sampling (CDS) operation. We also study the effective RN bandwidth, which increases due to the ramp slope transient effect and introduces a noise bandwidth (NBW) coefficient, to estimate the effective NBW. This study provides insights into the area arrangement of the small-pixel DPS design. A high-gain single-ended comparator is introduced to realize an area-efficient DPS without digital CDS (D-CDS). Noise analysis of its pixel design shows that FN becomes the main contributor, and further RN improvement by limiting NBW or D-CDS is not promising under these conditions.