The rise in atmospheric CO2 intensified the urgency for carbon capture and storage (CCS), yet uncertainties remain in predicting evolution of reservoir properties under CO2 injection. This study investigates how CO2–brine–rock interactions alter porosity and permeability in carbonate and sandstone reservoirs. We quantify pore-scale changes and effects of CO2-saturated brine on rock. In calcite-rich carbonates, CO2-induced acidification enhances permeability through selective dissolution. Dolomite-rich samples and sandstones exhibit suppressed permeability response due to slower dissolution and pore clogging. μCT and SEM reveal that although bulk porosity changes are small, local changes—especially formation of micropores and mineral occlusions—substantially influence permeability. Geochemical modeling confirms three-stage evolution: early dissolution, intermediate buffering with onset of precipitation, and long-term mineral trapping with near-steady porosity. The results indicate that early injectivity gains may be temporary and that proactive monitoring and management are required to safeguard long-term storage integrity. The findings provide actionable insight for sustainable CCS design, risk assessment, and reservoir stewardship.
This paper is focused on the determination of the physicochemical properties of a composite inorganic–organic modified membrane. The electrical conductivity of a family of glassy protonic electrolytes defined by the general formula (P2O5)x(SiO2)y, where x/y is 3/7 are studied by Alternating Current electrochemical impedance spectroscopy (AC EIS) method. The reference glass was doped with polymeric additives—poly(ethylene oxide) (PEO) and poly(vinyl alcohol) (PVA), and additionally with a titanium-oxide-based filler. Special attention was paid to determination of the transport properties of the materials thus modified in relation to the charge transfer phenomena occurring within them. The electrical conductivities of the ‘dry’ material ranged from 10−4 to 10−9 S/cm, whereas for ‘wet’ samples the values were ~10−3 S/cm. The additives also modified the pore space of the samples. The pore distribution and specific surface of the modified glassy systems exhibited variation with changes in electrolyte chemical composition. The mechanical properties of the samples were also examined. The Young’s modulus and Poisson’s ratio were determined by the continuous wave technique (CWT). Based on analysis of the dispersion of the dielectric losses, it was found that the composite samples exhibit mixed-type proton mobility with contributions related to both the bulk of the material and the surface of the pore space.
In response to the imperative to mitigate methane—one of the most potent greenhouse gases—this study proposes and tests an integrated workflow for designing methane drainage boreholes targeting post-mining areas in an active underground coal mine (Pniówek, Poland). The workflow combines the following: (1) forecasting methane emissions from goafs and active longwalls for 2024–2040; (2) 3D geological characterization (structural and lithofacies models); (3) selection and sealing of goaf zones; and (4) optimization of well placement, drilling, and performance evaluation of drainage boreholes, including an assessment of energy use from the recovered gas. Applying the method delineated priority capture zones and estimated recoverable rates under multiple scenarios. Preliminary field data from a borehole near seam 362/1 indicate stable methane inflow to the drainage system and a concomitant reduction in methane load within the ventilation network. The integrated design improves targeting efficiency and provides a quantitative basis for scheduling, risk management, and sizing of surface-to-underground infrastructure. The results suggest that systematic drainage of post-mining voids can enhance safety, limit fugitive emissions, and create opportunities for on-site power generation. The approach is transferable to other active mines with legacy workings, provided site-specific calibration and monitoring are implemented.