Vladivoj Očenášek

Dr. Vladivoj Očenášek


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 November 2019 in Metals
Verified
Journal Article
Open access
PDF file
ISIvo Schindler
Ivo Schindler
PKPetr Kawulok
Petr Kawulok
VOVladivoj Očenášek
Vladivoj Očenášek
POPetr Opěla
Petr Opěla
RKRostislav Kawulok
Rostislav Kawulok
SRStanislav Rusz
Stanislav Rusz
Stress-strain curves of the EN AW 6082 aluminium alloy with 1.2 Si-0.51 Mg-0.75 Mn (wt.%) were determined by the uniaxial compression tests at temperatures of 450–550 °C with a strain rate of 0.5–10 s−1. The initial structure state corresponded to three processing types: as-cast structure non-homogenized or homogenized at 500 °C, and the structure after homogenization and hot extrusion. Significantly higher flow stress appeared as a result of low temperature forming of the non-homogenized material. Hot deformation activation energy Q-values varied between 99 and 122 kJ·mol−1 for both homogenized materials and from 200 to 216 kJ·mol−1 for the as-cast state, while the Q-values calculated from the measured steady-state stress were always higher than those calculated from the peak stress values. For the extruded state of the 6082 alloy, the physically-based model was developed to reliably predict the flow stress influenced by dynamic softening, temperature, strain rate, and true strain up to 0.6.

1 October 2016 in Manufacturing Technology
Verified
Journal Article
Open access
PDF file
JLJan Luštinec
Jan Luštinec
VOVladivoj Očenášek
Vladivoj Očenášek
MJMiroslav Jelínek
Miroslav Jelínek
The manufacture of die forgings from Al-Mg-Si type alloys is one of important topics of material and forming technology development. One of innovation factors affecting the forging technology is based on the use of continually cast rods instea...

26 February 2022 in Manufacturing Technology
Verified
Journal Article
Open access
PDF file
VOVladivoj Očenášek
Vladivoj Očenášek
JLJan Luštinec
Jan Luštinec

22 December 2023 in Manufacturing Technology
Verified
Journal Article
Open access
PDF file
JLJan Luštinec
Jan Luštinec
MRMiroslav Roško
Miroslav Roško
VOVladivoj Očenášek
Vladivoj Očenášek
The paper deals with the technology of production of deep-drawn plates from alpha brass CuZn30. Surface and hidden defects are often observed in these deep-drawn sheets. The research was aimed at reducing the occurrence of these defects and subsequently reducing scrap and increasing the quality of these metallurgical products with a tighter tolerance of the required structural and mechanical properties throughout the length and width of the sheets. The production technology was monitored from the preparation of the batch and casting parameters on the existing operating equipment, through the processing of the ingots by hot and cold rolling, to the recrystallization annealing of the sheets in coils in a hatch furnace and the subsequent continuous pickling and passivation of the final strips. Properties were monitored after each technological operation of production. Specifically, macrostructure, microstructure, microporosity, tensile mechanical properties, and hardness were analysed. The results showed that the chosen production technology has sufficient homogeneity of properties.