Application of biochar from vine shoots (Vitis vinifera L.) as an organic amendment in the soil is an alternative agricultural management of interest. The behavior of this type of amendment in the soil requires more information to adjust the pyrolysis conditions in order to obtain a high-quality biochar. The aim of this work is determining the influence of the application of this type of biochar on the soil-plant system. For this purpose, an agronomic test was performed in greenhouse pots. A randomized tri-factorial block design was adopted with the following factors: final pyrolysis temperature (400 and 600 °C), application rate (0 wt. % as a control, 1.5 and 3 wt. %) and texture of the growing media (sandy-loam and clay-loam origin). The selected crop was sorghum (Sorghum bicolor L. Moench), the development and production of which was evaluated during two complete growing cycles under greenhouse conditions. Application of biochar produced at 400 °C significantly increased plants roots dry weight in the sandy-loam growing substrate (52% compared to the control). Grain production was also significantly affected by biochar application, showing better results after addition of biochar produced at 400 °C. Water holding capacity and K, Ca, and Mg contents were enhanced by biochar addition, with evident effects of the application ratios for some of these variables. The effect on the pH of substrates in the sandy-loam texture was weak; however, a significant decrease was observed after the addition of biochar produced at 600 °C.
The effects of biochar on soil–plant–microorganisms systems are currently being extensively investigated. Considering that arbuscular mycorrhizal fungi (AMF) play an essential role in nutrient dynamics, the present study aims at understanding vine shoot-derived biochar effects on AMF activity and the impact of their multiplication in soils on water-stress resistance of plants. Three agronomic tests were performed in greenhouse pots. The first experiment evaluated the effects of three factors: final pyrolysis temperature for biochar production (400 °C and 600 °C), application rate (0 weight-wt.- % as a control, 1.5 wt. %, and 3.0 wt. %) and texture of the growing media (sandy-loam and clay-loam origin) on AMF, microbial communities and phosphatase activity. In the second experiment, an indigenous consortium of AMF was multiplied through the solid substrate method and sorghum as a trap plant with biochar addition. This process was compared to a control treatment without biochar. Obtained inocula were tested in a third experiment with lettuce plants under different water irrigation conditions. Results from the first experiment showed a general increase in AMF activity with the addition of the biochar produced at 400 °C in the sandy-loam texture substrate. Results of the second experiment showed that the biochar addition increased AMF root colonization, the number of AMF spores and AMF infective potential. Results of the third experiment showed that biochar-derived AMF inoculum increased AMF root colonization, AMF spores, dry biomass and the SPAD index in a lettuce crop under low-water irrigation conditions.
Rising soil salinity poses significant challenges to Mediterranean viticulture. While some rootstocks effectively reduce salt accumulation in grafted scions, the mechanisms and performance of novel rootstocks remain largely unexplored. This study compared two novel M-series rootstocks (M2, M4) with established commercial rootstocks (1103 Paulsen, R110) to evaluate their physiological responses and salt tolerance under irrigation with varying salinity levels (0, 25, 50, and 75 mM NaCl) over 5 months. Growth parameters, photosynthetic efficiency, chlorophyll content (SPAD), ion homeostasis, and visual symptoms were monitored. Results revealed genotype-specific strategies: 1103 Paulsen exhibited robust photosynthetic efficiency and ion exclusion, maintaining growth and chlorophyll stability; M2 demonstrated superior biomass retention and moderate ion compartmentalization but showed reduced photosynthetic performance at higher salinity levels; R110 displayed effective ion management at moderate salinity but experienced significant growth reduction under severe stress; and M4 was the most sensitive, with severe reductions in growth and ion homeostasis. Organ-specific responses highlighted roots acting as primary ion reservoirs, particularly for sodium and calcium; leaves exhibited high potassium and chloride concentrations, critical for photosynthesis but prone to ionic imbalance under stress; and stems and wood played a buffering role, compartmentalizing excess sodium and minimizing damage to photosynthetic tissues. The reported findings provide valuable insights for rootstock selection and breeding programs, particularly for regions facing increasing soil and water salinization challenges.
Introduction: This study explores the integration of precision agriculture technologies (PATs) in rainfed cereal production within semi-arid regions. Methods: utilizing the Veris 3100 sensor for apparent soil electrical conductivity (ECa) mapping, differentiated management zones (MZs) were established in experimental plots in Valsalada, NE Spain. Site-specific variable dose technology was applied for seed and fertilizer applications, tailoring inputs to distinct fertility levels within each MZ. Emphasizing nitrogen (N) management, the study evaluated the impact of variable-rate applications on crop growth, yield, nitrogen use efficiency (NUE), and economic returns. For the 2021/2022 and 2022/2023 seasons, seeding rates ranged from 350 to 450 grains/m2, and basal fertilizer dosages varied between high and low levels. Additionally, the total nitrogen units were distributed differently between the two seasons, while maintaining a uniform topdressing fertilizer dose across all treatments. Results: Results revealed a significant increase in yield in MZ 2 (higher fertility) compared to MZ 1 (lower fertility). NUE demonstrated notable improvement in MZ 2, emphasizing the effectiveness of variable-rate N applications. Economic returns, calculated as partial net income, showed a considerable advantage in MZ 2 over MZ 1, resulting in negative outcomes for low-fertility areas in several of the analyzed scenarios, and highlighting the financial benefits of tailored input management. Conclusion: This research provides quantitative evidence supporting the viability and advantages of adopting PATs in rainfed cereal production. The study contributes valuable insights into optimizing input strategies, enhancing N management, and improving economic returns in semi-arid regions.
The susceptibility to fragmentation of biochar is an important property to consider in field applications. Physical and mechanical properties of wood-derived biochars from vine shoots and holm oak were studied to evaluate the effect of biomass feedstock, final pyrolysis temperature and application conditions. Vine shoots and holm oak pruning residues were selected for biochar production. Slow pyrolysis experiments were conducted at two different final temperatures (400 and 600 °C). Physical and chemical characteristics of biomass and biochars were determined. Impact strength was evaluated through the measurement of the gravitational potential energy per unit area (J mm−2) necessary for the breakage of biochar fragments. Shear strength (N mm−2) and a combination of shear/compression strengths (N) were analyzed using a Universal Texture Analyzer. A particular mechanical treatment was carried out on biochar samples to simulate the processing bodies of a commercial manure spreader, under two gravimetric moisture contents. Holm oak-derived biochar was more resistant than vine shoot-derived biochar to the applied forces. Vine shoots-derived biochar did not show a significantly different mechanical behavior between temperatures. Holm Oak-derived biochar produced at the higher final pyrolysis temperature showed higher resistance to be broken into smaller pieces. Moistening resulted in an adequate practice to improve mechanical spreading.