Road agencies are constantly being placed in difficult situations when making road maintenance and rehabilitation decisions as a result of diminishing road budgets and mounting environmental concerns for any chosen strategies. This has led practitioners to seek out new alternative and innovative ways of monitoring road conditions and planning maintenance routines. This paper considers the use of innovative piezo-floating gate (PFG) sensors and conventional strain gauges to continuously monitor the pavement condition and subsequently trigger maintenance activities. These technologies can help develop optimized maintenance strategies as opposed to traditional ad-hoc approaches, which often lead to poor decisions for road networks. To determine the environmental friendliness of these approaches, a case study was developed wherein a life cycle assessment (LCA) exercise was carried out. Observations from accelerated pavement testing over a period of three months were used to develop optimized maintenance plans. A base case is used as a guide for comparison to the optimized systems to establish the environmental impacts of changing the maintenance workflows with these approaches. On the basis of the results, the proposed methods have shown that they can, in fact, produce environmental benefits when integrated within the pavement management maintenance system.

Pavement structures are designed to withstand continuous damage during their design life. Damage starts as soon as the pavement is open to traffic and increases with time. If maintenance activities are not considered in the initial design or considered but not applied during the service life, damage will grow to a point where rehabilitation may be the only and most expensive option left. In order to monitor the evolution of damage and its severity in pavement structures, a novel data compression approach based on cumulative measurements from a piezoelectric sensor is presented in this paper. Specifically, the piezoelectric sensor uses a thin film of polyvinylidene fluoride to sense the energy produced by the micro deformation generated due to the application of traffic loads. Epoxy solution has been used to encapsulate the membrane providing hardness and flexibility to withstand the high-loads and the high-temperatures during construction of the asphalt layer. The piezoelectric sensors have been exposed to three months of loading (approximately 1.0 million loads of 65 kN) at the French Institute of Science and Technology for Transport, Development and Networks (IFSTTAR) fatigue carrousel. Notably, the sensors survived the construction and testing. Reference measurements were made with a commercial conventional strain gauge specifically designed for measurements in hot mix asphalt layers. Results from the carrousel successfully demonstrate that the novel approach can be considered as a good indicator of damage progression, thus alleviating the need to measure strains in pavement for the purpose of damage tracking.

The objective of this paper is to present a novel approach for the continuous monitoring of pavement condition through the use of combined piezoelectric sensing and novel condition-based interpretation methods. The performance of the developed approach is validated for the detection of bottom-up fatigue cracking through full-scale accelerated pavement testing (APT). The innovative piezoelectric sensors are installed at the bottom of a thin 102 mm (4 in.) asphalt layer. The structure is then loaded until failure (up to 1 million loading cycles in this study). The condition-based approach, used in this work, does not rely on stain measurements and allows users to bypass the need for any structural or finite-element models. Instead, the data compression approach relies on variations in strain energy harvested by smart sensors to track changes in material and structural conditions. Falling weight deflectometer (FWD) measurements and visual inspections were used to validate the observations from the sensing system. The results in this paper present a first large-scale validation in pavement structures for a piezopowered sensing system combined with a new response-only based approach for data reduction and interpretation. The proposed data analysis method has demonstrated a very early detection capability compared to classical inspection methods, which unveils a huge potential for improved pavement monitoring.