Inconel 718 is a precipitation strengthened, nickel-based super alloy of interest for the Additive Manufacturing (AM) of low volume, complex parts to reduce production time and cost compared to conventional subtractive processes. The AM process involves repeated rapid melting, solidification and reheating, which exposes the material to non-equilibrium conditions that affect elemental segregation and the subsequent formation of solidification phases, either beneficial or detrimental. These variations are difficult to characterize due to the small length scale within the micron sized melt pool. To understand how the non-equilibrium conditions affect the initial solidification phases and their critical temperatures, a multi-length scale, multi modal approach has been taken to evaluate various methods for identifying the initial phases formed in the as-built Inconel 718 produced by laser-powder bed fusion (L-PBF) additive manufacturing (AM). Using a range of characterization tools from the bulk differential thermal analysis (DTA) and x-ray diffraction (XRD) to spatially resolved images using a variety of electron microscopy tools, a better understanding is obtained of how these minor phases can be properly identified regarding the amount and size, morphology and distribution. Using the most promising characterization techniques for investigation of the as-built specimens, those techniques were used to evaluate the specimens after various heat treatments. During the sequence of heat treatments, the initial as-built dendritic structures recrystallized into well-defined grains whose size was dependent on the temperature. Although the resulting strength was similar in all heat treated specimens, the elongation increased as the grain size was refined due to differences in the precipitated phase distribution and morphology.
Applications and adoption of metal additive manufacturing (AM) are increasing for fabrication of low volume, complex components with novel materials, as well as replacement parts. While the use of powder bed fusion-based processes have been widely used to build complex components with fine feature resolution, there is a volume limitation. Expanding the application of metal AM will rely on other processes that remove this build size constraint. These processes are referred to as Directed Energy Deposition (DED) and can use either powder or wire feedstock. Wire based DED provides the highest deposition rates which shortens the fabrication time making it attractive for fabrication of large parts replacing traditional wrought billets or castings. In this study, an iron-based austenitic superalloy (JBK-75) was deposited using an arc-based, wire-fed (AW)-DED process. The material was metallographically characterized and quasi-static mechanical properties were obtained. The resulting microstructure and mechanical properties are compared with conventional wrought and cast forms of JBK-75 subjected to the same heat treatments. As compared to wrought material, the AW-DED grain size was larger after the heat treatment, although the strengths were similar. Improved homogenization was observed after heat treatment in the AW-DED specimens as compared to the cast specimens.