For a clamp-on ultrasonic flowmeter based on transit-time differential method, the flow rate calculation model with flow velocity correction is established and verified by experiments carried out in a flow standard facility. Based on established flow rate calculation model, a systematic methodology incorporating the parametric uncertainty distribution is proposed to analyze the influences of multiple parameters with uncertainty on measurement error by establishing the sample-based stochastic model. Monte Carlo sampling (MCS) method is used to randomly select the value of each parameter from its prescribed Gaussian distribution and then combining them together as one sample, and the number of selected samples is determined by conducting stochastic convergence analysis of mean value and the standard deviation of input and output parameters. And finally the influence degrees of multiple parameters are analyzed and compared quantitatively on the same dimension to find out which parameters are influential and which are negligible. The results reveal the different influences of multiple parameters with uncertainty, which can be used as reference for performance improvement and measuring error analysis of the clamp-on ultrasonic flowmeter in industrial local measurement.
The relationship between flow fluctuation and pressure in a flow facility is studied theoretically and experimentally in this paper, and a method for measuring the flow fluctuation is proposed. According to the synchronicity of pressure and flow fluctuation, the amplitude of the flow fluctuation is calculated using the pressure measured in the flow facility and measurement of the flow fluctuation in a wide range of frequency is realized. Based on the method proposed, uncertainty analysis is used to evaluate the influences of different parameters on the flow fluctuation by the help of a sample-based stochastic model established and the parameters that have great influence are found, which can be a reference for the optimization design and the stability improvement of the flow facility.
In order to accurately evaluate the flow stability of the flow standard facility, the flow fluctuation in the standard facility needs to be accurately measured. However, the flow fluctuation signal is always superimposed with the fluctuation signal of the measuring flowmeter or measurement system (mainly noise), which leads to inaccurate measurement of the flow fluctuation and even an unreliable evaluation result of the flow stability. In addition, when there are multiple fluctuation sources, flow fluctuations with different frequencies are superimposed together, which is extremely unfavorable for evaluating the impact of flow fluctuation with different single frequencies. In this paper, a new measuring method was proposed to obtain the fluctuation signal and the flow fluctuation based on singular value decomposition (SVD). Simulation experiments on the fluctuation signal (single frequency and multiple frequencies) under different levels of noise were conducted, and simulation results showed that the proposed method could accurately obtain the fluctuation signal and the flow fluctuation, even under high noise. Finally, an experimental platform was set-up based on a water flow standard facility and a flow fluctuation generator, and experiments on the output signal of a venturi flowmeter were carried out. The experiment results showed that the proposed method could effectively obtain the fluctuation signal and accurately measure the flow fluctuation.
Reliable three-dimensional (3D) object detection is critical for intelligent vehicles to ensure safety in complex traffic environments, and recent progress in multi-modal sensor fusion, particularly between LiDAR and camera, has advanced environment perception in urban driving. However, existing approaches remain vulnerable to occlusions and dense traffic, where depth estimation errors, calibration deviations, and cross-modal misalignment are often exacerbated. To overcome these limitations, we propose BEVAlign, a local–global feature alignment framework designed to generate unified BEV representations from heterogeneous sensor modalities. The framework incorporates a Local Alignment (LA) module that enhances camera-to-BEV view transformation through graph-based neighbor modeling and dual-depth encoding, mitigating local misalignment from depth estimation errors. To further address global misalignment in BEV representations, we present the Global Alignment (GA) module comprising a bidirectional deformable cross-attention (BDCA) mechanism and CBR blocks. BDCA employs dual queries from LiDAR and camera to jointly predict spatial sampling offsets and aggregate features, enabling bidirectional alignment within the BEV domain. The stacked CBR blocks then refine and integrate the aligned features into unified BEV representations. Experiment on the nuScenes benchmark highlights the effectiveness of BEVAlign, which achieves 71.7% mAP, outperforming BEVFusion by 1.5%. Notably, it achieves strong performance on small and occluded objects, particularly in dense traffic scenarios. These findings provide a basis for advancing cooperative environment perception in next-generation intelligent vehicle systems.