The conducting polymer of poly(3,4 ethylenedioxythiophene):poly(4-styrenesulfonate) (PEDOT:PSS) is one of the most important and intensively investigated organic conducting materials. The PEDOT:PSS water dispersions with various concentrations of poly (4-styrenesulfonic acid) solution (PSSAS) were synthesized by 3,4-ethylenedioxythiophene (EDOT) in the presence of water. The fabrication of the solvent-treated PEDOT:PSS films through spin coating and solvent treatment processes was achieved with a solvent of pure water mixed with acetone (or MeOH, EtOH) in a ratio of 50:50. Moreover, both the organic solvent and water have synergetic effects while the PSS and PEDOT-attached PSS segments will form a coil-like and a linear (or extended-coil) structure, respectively. That may induce a stacking of the linear and planar PEDOT-attached PSS segments, which favors the formation of a crystalline phase. Finally, the maximum electrical conductivity of the PEDOT:PSS thin films with solvent treatment was investigated by means of X-ray diffraction (XRD) patterns and scanning electron microscope (SEM) images. Furthermore, we aimed to explain the synergetic effects of phase separation of the PEDOT:PSS thin films by both the organic solvent and water.

N¹, N⁶-bis (4-aminobutyl) adipamide (BABA) diamine and sebacic acid (SA), also called BABA/SA polyamide salt, were used in a typical melt polymerization processes of polyamide 6 (PA6) to form a series of PA6-BABA/SA copolyamides. The effects of BABA/SA on the isothermal crystallization kinetics of PA6-BABA/SA were studied for the first time. An isothermal crystallization analysis demonstrates that the PA6-BABA/SA matrix provided a higher crystallization rate and shorter half-crystallization time than virgin PA6 did. The degree of crystallization of the PA6-BABA/SA₃₀ matrix was also the lowest among all of the samples considered herein. This result is attributed to the high nucleation efficacy of a small amount of BABA/SA in the crystallization of PA6. Values of the Avrami exponent (n) from 1.84 to 3.91 were observed for all of the polyamide samples, suggesting that the crystallization was involved via a two- to three-dimensional growth mechanism. These findings deepen our understanding of the structure–property relationship of PA6-BABA/SA copolyamides, favoring their practical application.

Recycled waste industrial cellulose triacetate (TAC) film, which is one of the key materials in polarizers, was used to produce nanofiber membranes by electrospinning and synergistic assembly with graphene oxide (GO) and titanium dioxide (TiO₂) for oil-water separation. In this study, GO and TiO₂ coated by an electrophoretic deposition method introduced super hydrophilicity onto the recycled TAC (rTAC) membrane, with enhanced water permeability. The results indicate that when the outermost TiO₂ layer of an asymmetric composite fiber membrane is exposed to ultraviolet irradiation; the hydrophilicity of the hydrophilic layer is more effectively promoted. Moreover, this coating could efficiently repel oil, and demonstrated robust self-cleaning performance during the cycle test, with the aid of the photocatalytic properties of TiO₂. The rTAC membrane of networked hydrophobic fibers could also increase the speed of the filtrate flow and the water flux of the oil-water emulsion. The permeate carbon concentration in the water was analyzed using a total organic carbon analyzer. Incorporation of TiO₂/GO onto the rTAC membrane contributed greatly towards enhanced membrane hydrophilicity and antifouling performance. Therefore, the novel TiO₂/GO/rTAC asymmetric composite fiber has promise for applications in oil-water separation.