Background: Plasma creatinine concentration and calculated creatinine clearance are of limited value as glomerular filtration rate (GFR) markers in patients with decompensated liver cirrhosis. We assessed plasma cystatin C as an indicator of GFR in such patients. Methods: We studied 36 patients with decompensated liver cirrhosis and 56 noncirrhotic controls, both groups including individuals with normal and impaired renal function. GFR was measured in all individuals by inulin clearance, with values <72 mL · min−1 · 1.73 m−2 considered decreased. We measured cystatin C and creatinine in plasma and calculated (from plasma concentrations) and measured creatinine clearances, using for them decision points of 1.25 mg/L, 115 μmol/L, and 72 and 72 mL · min−1 · 1.73 m−2, respectively. Results: Plasma cystatin C concentrations were similar in controls and cirrhotics and, at the usual cutpoint, could detect decreased GFR with similar sensitivities in the two groups (73% and 88%, respectively). Serum creatinine was markedly lower in cirrhotics and remained mostly within the reference interval at all GFR values; the diagnostic sensitivity of creatinine was much lower in cirrhotics than in controls (23% vs 64%). Lower diagnostic sensitivity was also observed for calculated creatinine clearance (53% vs 100% in controls), whereas similar sensitivities were found for measured creatinine clearance (86% and 81%) in controls and cirrhotics, respectively. ROC analysis showed that all four variables had similar diagnostic accuracies in cirrhotic patients. However, it also revealed that good diagnostic accuracies for plasma creatinine and calculated creatinine clearance can be obtained only if reference intervals different from those used for the general population are adopted. Conclusions: Plasma cystatin C concentration is an accurate GFR marker in cirrhotic patients. Plasma creatinine concentration and calculated creatinine clearance are of no practical value, as their reference values vary with the severity of the liver disease.
11 April 2006 in Clinical Pharmacology & Therapeutics
Jams are appreciated worldwide and have become a growing market, due to the greater attention paid by consumers for healthy food. The selected products for this study represent a segment of the European market that addresses natural products without added sucrose or with a low content of natural sugars. This study aims to identify volatile organic compounds (VOCs) that characterize three flavors of fruit and five recipes using gas chromatography–mass spectrometry (GC–MS) and solid-phase micro-extraction (SPME) analysis. Furthermore, an innovative device, a small sensor system (S3), based on gas sensors with nanomaterials has been used; it may be particularly advantageous in the production line. Results obtained with linear discriminant analysis (LDA) show that S3 can distinguish among the different recipes thanks to the differences in the VOCs that are present in the specimens, as evidenced by the GC–MS analysis. Finally, this study highlights how the thermal processes for obtaining the jam do not alter the natural properties of the fruit.
Nowadays, innovation in food technologies is fundamental and consumers are increasingly aware and demanding. To create a final product that is more and more appealing, health and safety guidelines are pushing towards new challenges. It is precisely due to the high quality required by the producers that the aim discussed in this project has been conceived. Until today, the controls on the entire production line have been slowed down by the limitations of the technologies involved, including the high cost of instrumentation for microbiological analysis, the need for qualified personnel to carry them out, the long execution times and the invasiveness of the techniques themselves. This project has, therefore, proposed a user-friendly solution that is minimally invasive, fast and at a lower cost. This system makes use of classical microbiological analysis and, in parallel, use of an innovative electronic-nose small sensor system (S3+), which can be trained to recognize the volatile fingerprint of a specific product and customized for a specific use. The aim of this project was to develop a system that is able to detect the mold contamination on fruit and vegetable jams and marmalades, using a new kind of innovative metal semiconductor gas sensor (MOS) device. The application of this technology has, therefore, made it possible to classify various samples of uncontaminated and contaminated fruit and vegetable preparations. Thanks to the classification implemented by a data-driven algorithm, it has been possible to build an anomaly detector that is able to recognize the occurrence of possible contamination, thus acting as an early alert system in the food chain. All this will occur in less than 1 min once the system is trained, in contrast with classical microbiological or chemical techniques that normally require longer timeframes to obtain a result and involve the use of reagents, increasing the costs.