Andrzej Gruchot

Dr. Andrzej Gruchot

orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 January 2021 in Sustainability
Verified
Journal Article
Open access
PDF file
KKKarolina Koś
Karolina Koś
AGAndrzej Gruchot
Andrzej Gruchot
EZEugeniusz Zawisza
Eugeniusz Zawisza
A possibility of using bottom sediments from dam reservoirs in earth structures was considered. Sediments from the Rzeszow reservoir (Poland) were used as research material, which, according to geotechnical standards, were classified as low permeable silt with high organic content. As fine, cohesive soil with a low coefficient of permeability, the sediments can be used in sealing elements of hydraulic engineering embankments. In order to verify the suitability of the sediments, stability and filtration calculations were carried out for embankments with a sealing in the form of a core made of the sediments. It was stated that by using a core made of sediments, the volume of seepage on the downstream side during continuous or variable backwater was significantly lower in relation to an embankment without a core, and the phreatic line did not extend to the downstream slope. It is estimated that, in the case of a planned dredging in Rzeszow Reservoir, the amount of dredged sediment would exceed 1.5 million m3, and therefore, the possibility of their economic use is essential. The search for materials that could replace natural soil in earthen structures is an important issue from both the ecological and economic points of view.

21 February 2025 in Materials
Verified
Journal Article
Open access
PDF file
AGAndrzej Gruchot
Andrzej Gruchot
KKKatarzyna Kamińska
Katarzyna Kamińska
AWAgnieszka Woś
Agnieszka Woś
This article presents the results of laboratory tests of compaction parameters and shear strength of silty soils with and without the addition of hydraulic binder in the form of lime and/or cement. The tests were carried out on samples formed with an optimum moisture content and with 0, 3, 5, and 8% hydraulic binder added to the dry mass of the soil. The soil samples were examined after 7 and 14 days of air–water treatment without and with freeze–thaw cycles. It was found that the addition of lime and cement caused changes in the compaction parameters. This effect depended to a large extent on the type of binder, and also on the grain size composition of the tested soil. The tests showed that the shear strength and the parameters describing it, i.e., the angle of internal friction and cohesion, were high and largely depended on the type of binder and the sample treatment method, as well as its duration. The obtained results indicate that the use of hydraulic binders was an effective method of surface stabilization. Improving soil properties based on the addition of a hydraulic binder is a beneficial method for the environment from the viewpoint of sustainable development and reducing CO2 emissions because it does not require the use of, e.g., soil replacement. Using the SHAP algorithm, it was found that normal stress, initial moisture content, and curing time of the samples were the main input features that influenced the shear strength.

20 April 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
AGAndrzej Gruchot
Andrzej Gruchot
TZTymoteusz Zydroń
Tymoteusz Zydroń
Andrzej WalegaAndrzej Walega
Andrzej Walega
JPJana Pařílková
Jana Pařílková
JSJacek Stanisz
Jacek Stanisz
This paper presents the results of laboratory tests that allowed us to determine the effect of the soil surface inclination and its initial moisture content on the formation of overland and subsurface runoff. The experiments were carried out for the soil that is commonly present in the southern part of Poland, including the Outer Carpathians. The results of these measurements served as a reference for overland runoff calculations using the Richards model, simplified Green–Ampt model, and the empirical model (MSME). The results of the measurements showed that, for low-permeable soil, overland runoff is the dominant form. It was shown that a slope in the range of 2.5–5.0% does not have a significant effect on the amount of overland runoff, but affects its dynamics. The measurements also showed that the starting time and amount of overland runoff are strictly associated with the initial soil moisture content. High soil moisture content in the period preceding the onset of rainfall causes faster generation and an increase in overland runoff, which is caused by the saturation of the surface layer of the soil. This mechanism was confirmed by the results of calculations using the Richards model and measurements of the electrical resistance of the soil. Theoretical calculations showed that the results of the runoff calculations using the Richards and Green–Ampt models are strongly dependent on the hydraulic properties of the soil adopted for the analysis. It was also demonstrated that the modified MSME model satisfactorily estimates the amount of overland and subsurface runoff, but requires parameter calibration based on existing hydrological data.

29 July 2021 in Energies
Verified
Journal Article
Open access
PDF file
EPElżbieta Pilecka
Elżbieta Pilecka
JSJacek Stanisz
Jacek Stanisz
RKRobert Kaczmarczyk
Robert Kaczmarczyk
AGAndrzej Gruchot
Andrzej Gruchot
The slopes of open-pit mines are often at risk of failure. To identify this hazard, stability analyses are performed. An important element of these stability analyses is the reliable selection of input parameter values for the calculations. This selection is difficult because the slopes of the open pit are disturbed by mining activities. In such conditions, rheological processes, intensified by weathering, develop in open-pit slopes. This study is aimed at setting the strength parameters for the stability analysis of open-pit slopes with a developed slide process, using the random set method. The study was performed on the example of the open pit of the Bełchatów lignite mine, central Poland. A four-stage methodology, according to the random set method, was proposed. The methodology covered the following: site investigation, sensitivity analyses, shear strength reduction (SSR) analyses using numerical calculations, and probability analyses of the factor of safety (FoS) calculation results. The setting of the input parameters took into account the peak and residual strength parameters for each lithological unit in the physical model of the open-pit slope. Samples for laboratory tests were taken from the cores of nine test boreholes. The sensitivity analysis included all peak and residual strength parameters for each lithological unit in the body. As a result of the sensitivity analysis, specific strength parameters were adopted that would have a great impact upon the results of the calculations. Selected sets of parameter values were then used for the FoS calculations. The resultant FoS values revealed the probable slide planes. The positions of the slide planes were consistent with the interpreted slide surfaces based on the control boreholes and terrain observations. Knowledge of the slide planes positions and the values of the strength parameters enabled the designing of a securing approach for this landslide, and the taking of preventive measures to reduce this risk.

28 December 2019 in Applied Sciences
Verified
Journal Article
Open access
PDF file
AGAndrzej Gruchot
Andrzej Gruchot
TZTymoteusz Zydroń
Tymoteusz Zydroń
The paper presents the results of research on the influence of compaction on the shear strength of fly ash, unburnt and burnt coal wastes, and a composite (a mixture of unburnt coal waste and 30% of fly ash). The tests were carried out in a triaxial compression apparatus on samples with a diameter and height of 10 and 20 cm, respectively. In order to verify usability of the tested waste materials for earthworks, stability calculations of the road embankment made of these materials were carried out. It was shown that the tested materials were characterized by high values of shear strength parameters, which significantly depended on compaction. The most favorable values of the angle of internal friction and cohesion were obtained for the burnt coal waste, slightly lower for the composite, and the lowest for the fly ash. Stability calculations for the road embankment model showed that the slope inclination and the load on the embankment have a significant influence on the factor of safety. It was also shown that a decrease in cohesion causes significant decrease in the factor of safety. The tests and the stability calculations showed that the tested waste materials are useful for earth construction purposes.

8 July 2019 in Polish Journal of Environmental Studies
Verified
Journal Article
Closed access
TZTymoteusz Zydroń
Tymoteusz Zydroń
AGAndrzej Gruchot
Andrzej Gruchot
MKMarcin Kluba
Marcin Kluba
Our work aimed to determine the spatial distribution of the root cohesion of the roots of 8-year-old black locust and black poplar trees. The scope of our research and analyses included determining characteristics of root systems of the studied tree species by profiling the walls of a trench with a width and a depth of 1.0 m at a distance of 0.5 and 1.0 m from the trunks. Laboratory tests comprised determining the tensile strength of the selected root classes. A modified Schwarz model (RDM) was used to describe the horizontal distribution of roots in the soil. The increase in shear strength of the root-reinforced soil was determined by a strain bundle model in which the value of the force mobilized by the roots is described by the Weibull survival function (RBMw). The results of the root system measurements have shown that the black locust is characterized by a greater number of roots, while the roots of black poplar are thicker, which makes the relative surface of its roots larger. Calculations of root cohesion using the modified bundle model, taking into account the root system displacement, showed that the maximum value for the black locust was 9.4 and 6.4 kPa, and for the black poplar 6.4 and 6.2 kPa respectively at a distance of 0.5 and 1.0 m from the trunk. It was also shown that the optimal spacing of the trees of these species, necessary to achieve effective reinforcement of the soil, was approximately 4 m.