Seismic methods used in the study of snow avalanches may be employed to detect and characterize landslides and other mass movements, using standard spectrogram/sonogram analysis. For snow avalanches, the spectrogram for a station that is approached by a sliding mass exhibits a triangular time/frequency signature due to an increase over time in the higher-frequency constituents. Recognition of this characteristic footprint in a spectrogram suggests a useful metric for identifying other mass-movement events such as landslides. The 1 June 2005 slide at Laguna Beach, California is examined using data obtained from the Caltech/USGS Regional Seismic Network. This event exhibits the same general spectrogram features observed in studies of Alpine snow avalanches. We propose that these features are due to the systematic relative increase in high-frequency energy transmitted to a seismometer in the path of a mass slide owing to a reduction of distance from the source signal. This phenomenon is related to the path of the waves whose high frequencies are less attenuated as they traverse shorter source-receiver paths. Entrainment of material in the course of the slide may also contribute to the triangular time/frequency signature as a consequence of the increase in the energy involved in the process; in this case the contribution would be a source effect. By applying this commonly observed characteristic to routine monitoring algorithms, along with custom adjustments for local site effects, we seek to contribute to the improvement in automatic detection and monitoring methods of landslides and other mass movements.

In this paper, we take a hard look at the performance of REMOTE, a sensor network based application that provides a detailed picture of a boat movement, individual rower performance, or his/her performance compared with other crew members. The application analyzes data gathered with a WSN strategically deployed over a boat to obtain information on the boat and oar movements. Functionalities of REMOTE are compared to those of RowX [1] outdoor instrument, a commercial wired sensor instrument designed for similar purposes. This study demonstrates that with smart geometrical configuration of the sensors, rotation and translation of the oars and boat can be obtained. Three different tests are performed: laboratory calibration allows us to become familiar with the accelerometer readings and validate the theory, ergometer tests which help us to set the acquisition parameters, and on boat tests shows the application potential of this technologies in sports.

The changes in the seismic signals generated by avalanches recorded at three sites along a path at the Vallée de la Sionne (VdlS) experimental site are presented. We discuss and correlate the differences in the duration, signal amplitudes, and frequency content of the sections (Signal ONset (ON), Signal Body (SBO), and Signal TAil and Signal ENd STA-SEN) of the spectrograms with the evolution of the powder, transitional and wet snow avalanches along a path. The development of the avalanche front was quantified using the exponential function in time F (t) = K’ exp (β t) fitted to the shape of the signal ONset (SON section of the spectrogram. The speed of the avalanche front is contained in β. To this end, a new method was developed. The three seismic components were converted into one seismic component (FS), when expressing the vector in polar coordinates. We linked the theoretical function of the shape of the FS-SON section of the spectrogram to the numerical coefficients of its shape after considering the spectrogram as an image. This allowed us to obtain the coefficients K’ and β. For this purpose, the Hough Transform (HT) was applied to the image. The values of the resulting coefficients K’ and β are included in different ranges in accordance with the three types of avalanche. Curves created with these coefficients enable us to estimate the development of the different avalanche types along the path. Our results show the feasibility of classifying the type of avalanche through these coefficients. Average speeds of the avalanches approaching the recording sites were estimated. The speed values of wet and transitional avalanches are consistent with those derived from GEODAR (GEOphysical Doppler radAR) measurements, when available. The absence of agreement in the speed values obtained from seismic signals and GEODAR measurements for powder snow avalanches indicates, for this type of avalanche, a different source of the measured signal. Hence, the use of the two measuring systems proves to be complementary.

Avalanche research requires comprehensive measurements of sudden and rapid snow mass movement that is hard to predict. Automatic cameras, radar and infrasound sensors provide valuable observations of avalanche structure and dynamic parameters, such as velocity. Recently, seismic sensors have also gained popularity, because they can monitor avalanche activity over larger spatial scales. Moreover, seismic signals elucidate rheological properties, which can be used to distinguish different types of avalanches and flow regimes. To date, however, seismic instrumentation in avalanche terrain is sparse. This limits the spatial resolution of avalanche details, needed to characterise flow regimes and maximise detection accuracy for avalanche warning.As an alternative to conventional seismic instrumentation, we propose Distributed Acoustic Sensing (DAS) to measure avalanche-induced ground motion. DAS is based on fibre-optic technology, which has previously been used already for environmental monitoring, e.g., of snow avalanches. Thanks to recent technological advances, modern DAS interrogators allow us to measure dynamic strain along a fibre-optic cable with unprecedented temporal and spatial resolution. It therefore becomes possible to record seismic signals along many kilometres of fibre-optic cables, with a spatial resolution of a few metres, thereby creating large arrays of seismic receivers. We test this approach at an avalanche test site in the Valleé de la Sionne, in the Swiss Alps, using an existing 700 m long fibre-optic cable that is permanently installed underground for the purpose of data transfer of other, independent avalanche measurements.During winter 2020/2021, we recorded numerous snow avalanches, including several which reached the valley bottom, travelling directly over the cable during runout. The DAS recordings show clear seismic signatures revealing individual flow surges and various phases/modes that may be associated with roll waves and avalanche arrest. We compare our observations to state-of-the-art radar and seismic measurements which ideally complement the DAS data.Our initial analysis highlights the suitability of DAS-based monitoring and research for avalanches and other hazardous granular flows. Moreover, the clear detectability of avalanche signals using existing fibre-optic infrastructure of telecommunication networks opens the opportunity for unrivalled warning capabilities in Alpine environments.