We investigated the self-assembly of block copolymers during hollow fiber membrane (HFM) fabrication by conducting in situ small angle X-ray scattering (SAXS) and ex situ scanning electron microscopy (SEM) studies. SAXS enables us to follow the structural rearrangements after extrusion at different distances from the spinning nozzle. The kinetics of the spinning process is examined as a function of the composition of block copolymer solutions and the spinning parameters. We studied the influence of the extrusion rate on the block copolymer microdomains and their self-assembly in weakly segregated and ordered solutions. The addition of magnesium acetate (MgAc2) leads to the ordering of micelles in the block copolymer solution already at lower polymer concentrations and shows an increased number of micelles with larger domain spacing as compared to the pristine solution. The SAXS data show the effect of shear within the spinneret on the self-assembly of block copolymers and the kinetics of phase separation after extrusion. It is observed that the ordering of micelles in solutions is decreased as indicated by the loss of crystallinity while high extrusion rates orient the structures perpendicular to the fiber direction. The structural features obtained from in situ SAXS experiments are correlated to the structure in the block copolymer solutions in the absence of shear and the morphologies in flat sheet and HF membranes obtained by ex situ SEM. This allows a systematic and comparative study of the effects varying the microdomain ordering within different block copolymer solutions and the formed membrane structures.
The conventional fabrication of isoporous membranes via the evaporation-induced self-assembly of block copolymers in combination with non-solvent induced phase separation (SNIPS) is achieved under certain environmental conditions. In this study, we report a modification in the conventional fabrication process of (isoporous) flat sheet membranes in which the self-assembly of block copolymers is achieved by providing controlled evaporation conditions using gas flow and the process is introduced as gSNIPS. This fabrication approach can not only trigger and control the microphase separation but also provides isoporous structure formation in a much broader range of solution concentrations and casting parameters, as compared to fabrication under ambient, uncontrolled conditions. We systematically investigated the structure formation of the fabrication of integral asymmetric isoporous membranes by gSNIPS. A quantitative correlation between the evaporation conditions (causing solvent evaporation and temperature drop) and the self-assembly of block copolymers beginning from the top layer up to a certain depth, orientation of pores in the top layer and the substructure morphology has been discussed empirically.
Desalination membranes are essential for global freshwater production, yet the performance of conventionally synthesized membranes is limited by the lack of synthetic control over the selective film. Solvent-based polymerization methods result in inhomogeneous density, nodular morphology, and the presence of nanoscale defects that hinder salt and boron selectivities. By employing a vapor-phase synthesis strategy, we circumvent the reliance on solvent interfaces to create compositionally homogeneous, defect-free thin-film composite polyamide membranes with Angstrom-level control over thickness. With a structure and thickness defined with nanoscale precision, we measure previously inaccessible properties of membrane selective layers, including intrinsic water and salt permeabilities, and explore the limits of thickness on membrane performance. Membranes with a 12 nm, vapor-synthesized, selective layer exhibit a two-order-of-magnitude reduction in both salt ions and uncharged boron molecules permeabilities, and a twofold improvement in NaCl selectivity relative to commercial desalination membranes. Mechanistic analysis, supported by theoretical modeling and molecular dynamics simulations, demonstrates that salt permeability increases sharply for films thinner than the Bjerrum length, revealing a physical lower bound on selective-layer thickness. These results establish a high-precision platform for probing and optimizing molecular transport in thin-film composite membranes.