The laser forming technique has an important disadvantage, which is the limitation of plastic deformation generated by a single laser beam pass. To increase the plastic deformation it is possible to apply external forces in the laser forming process. In this paper, we investigate the influence of external pre-loads on the laser bending of steel plate. The pre-loads investigated generate bending towards the laser beam. The thermal, elastic-plastic analysis is performed using the commercial nonlinear finite element analysis package ABAQUS. The focus of the paper is to identify how this pattern of the pre-load influence the final bend angle of the plate.

Laser-assisted forming techniques have been developed in recent years to aid plastic working of materials, which are difficult in processing at normal temperatures due to a high brittleness, effects of high work-hardening or a high spring-back phenomenon. This paper reports initial experimental investigations and numerical simulations of a mechanically-assisted laser forming process. The research is aimed at facilitating plastic shaping of thin-walled parts made of high temperature resistant alloys. Stainless steel plate, 1 mm thick, 20 mm wide, was mounted in the cantilever arrangement and a gravitational load was applied to its free end. A CO₂ laser beam with rectangular cross-section traversed along the plate, towards the fixed edge. Laser spot covered the whole width of the plate. Experiments and simulations using the finite element method were performed for different values of mechanical load and with constant laser processing parameters. Experimentally validated numerical model allowed analysis of plastic deformation mechanism under the hybrid thermo-mechanical processing. The revealed mechanism of deformation consists in intense material plastic flow near the laser heated surface. This behavior results mainly from the tension state close to the heated surface and the decrease of material yield stress at elevated temperature. Stress state near the side edges of the processed plate favored more intense plastic deformation and the involved residual stress in this region.

Laser thermal forming is an application of laser heating without any intentional use of external forces. Force-assisted laser bending and laser-assisted bending are hybrid techniques, which combine the use of external forces and local heating to increase the effectiveness of forming. A quantitative description of bending deformation induced by concurrent laser heating and mechanical loading is proposed in this study. Mechanical loading is expressed by the bending moment while the curvature is used to describe the resulting deformation. The contribution of a relatively less known mechanism of laser thermal bending in the hybrid process is identified. The mechanism is able to produce the so-called convex deformation, i.e., bending away from the incident laser beam. Experimental and numerical analysis is performed with thin-walled beams made of Inconel 718 nickel-based superalloy in the factory-annealed state. The Johnson–Cook constitutive material model is used in numerical simulations validated by experimental results.

Artykuł Laserowe formowanie powłok o zadanym kształcie powierzchni rozwijalnej* | Mechanik Miesięcznik Naukowo-Techniczny