Scanning contact potentiometry (SCP) is a nondestructive method used for defects detection, and for determining the location coordinates of defects in welded joints. This paper evaluates the accuracy of SCP method in detecting defects and localising them in welded steel plates. The effectiveness of the SCP method was evaluated using sample of steel 321 H plates (Chromium–Nickel–titanium stainless steel), where sample plates were welded by means of manual arc welding, dimension of each 200 × 110 × 13.5 mm. After welding, welded sample was inspected using an X-ray radiographic testing system. In order to investigate SCP capabilities, plotted potentiograms were compared with the corresponding X-ray radiograph image. Furthermore, SCP signals were analysed using discrete Fourier transform. Experimental outcomes proved that defects can be detected by SCP technique more accurate comparative to X-ray. Also it is considered an inexpensive comparable to X-ray and ultrasound non-destructive testing methods. As a result, SCP may substitute some destructive or non-destructive testing methods.
1 January 2019 in Russian Journal of Nondestructive Testing
The processes of formation and growth of an incipient crack in EI847 steel have been studied by uniaxial constant-load tension testing on an INSTRON-5982 tensile testing machine using scanning...
The method of scanning contact potentiometry (SCP) was investigated in factory conditions and functional capabilities of electric non-destructive testing (NDT) method to detect structural heterogeneities and technological defects were demonstrated directly in the process of reactor equipment production.
A method of electrophysical chromatography was proposed to visualize the results of electrical non-destructive testing for the first time. Surface potentiograms usually used to represent the results of scanning contact potentiometry are replaced by volumetric images of structural inhomogeneities. The alternative has obvious advantages as useful additional information can drastically change the results of testing which is demonstrated by the example of a weld overlay. Methodological recommendations for constructing volumetric images of defects are formulated and implemented. The causes of self-shielding of structural inhomogeneities at different levels of fixation which are due to the mutual spatial overlap of microregions emitting waves of elastic stresses are discussed. The biggest problems in identifying defects for NDT are their complete or partial screening. The electrophysical chromatography method requires at least one experimental array obtained from the following measurements: double scanning of the surfaces of the test object; double simultaneous scanning of the surfaces of the test object; double simultaneous scanning of the surfaces of the test object using a radiation synchronizer in time or frequency. In the case of scanning along one (external or internal) surface, the coordinates of defects are determined from the corresponding cross sections and the calculated values of their depth using frequency and time-frequency analysis
Исследовано влияние дефектов механической обработки поверхности образца из сплава Д16Т на его деформационное упрочнение при растяжении в интервале прикладываемых напряжений от 50 до 500 МПа. При этом использованы методы сканирующей контактной потенциометрии и метод дифракции тепловых нейтронов. Показано, что в области упругой деформации при напряжении 50 МПа дефекты механической обработки, как и в случае нулевой нагрузки, сконцентрированы главным образом в середине и по краям образца. Следы точения и шлифовки поверхности в виде соответствующих пятен и полос на потенциограммах при нагрузках более 50 МПа на высоких уровнях фиксации трансформируются в отдельные рефлексы размерами 1-2 мм, которые представляют собой локальные области деформационно-упрочненного материала, излучающего волны механических...