The characteristics of the vertical and temporal structure of the coastal atmospheric boundary layer are variable for different sites and are often not well known. Continuous monitoring of the atmospheric boundary layer was carried out close to the Tyrrhenian Sea, near Tarquinia (Italy), in 2015–2017. A ground-based remote sensing instrument (triaxial Doppler sodar) and in situ sensors (meteorological station, ultrasonic anemometer/thermometer, and net radiometer) were used to measure vertical wind velocity profiles, the thermal structure of the atmosphere, the height of the turbulent layer, turbulent heat and momentum fluxes in the surface layer, atmospheric radiation, and precipitation. Diurnal alternation of the atmospheric stability types governed by the solar cycle coupled with local sea/land breeze circulation processes is found to be variable and is classified into several main regimes. Low-level jets (LLJ) at heights of 100–300 m above the surface with maximum wind speed in the range of 5–18 m s⁻¹ occur in land breezes, both during the night and early in the morning. Empirical relationships between the LLJ core wind speed characteristics and those near the surface are obtained. Two separated turbulent sub-layers, both below and above the LLJ core, are often observed, with the upper layer extending up to 400–600 m. Kelvin–Helmholtz billows associated with internal gravity–shear waves occurring in these layers present opposite slopes, in correspondence with the sign of vertical wind speed gradients. Our observational results provide a basis for the further development of theoretical and modelling approaches, taking into account the wave processes occurring in the atmospheric boundary layer at the land–sea interface.

Flux–profile relationships are crucial for parametrizing surface fluxes of momentum and heat, that are of central relevance for applications such as climate modelling and weather forecast. Nevertheless, their functional forms are still under discussion, and a generally accepted formulation does not exist yet. We reviewed the four main formulations proposed in the literature so far and assessed how they affect the theoretical behaviour of the kinematic heat flux ($H_0$) and the temperature scale ($T_{*}$) in the stable boundary layer, as well as their consequences on the existence of critical values for both the gradient and the flux Richardson numbers. None of them turned out to be fully consistent with the literature published so far, with two of them leading to very unreliable expressions for both $H_0$ and $T_{*}$. All considered, a convincing description of flux–profile relationships still needs to be found and seems to represents a considerable challenge.

Numerical weather prediction models require an accurate parametrization of the energy budget at the air-ground interface, that can be obtained only through long-term atmospheric boundary layer measurements at different spatial and temporal scales. Despite their importance, such measurements are still scarce even in well-characterized areas. In this paper, a three-year dataset from four micrometeorological stations run by the Regional Agency for Environmental Protection of Lazio was analyzed to estimate albedo, zero-displacement height, roughness length and surface properties over Rome and its suburbs, characterizing differences and interconnections between urban, suburban and rural areas of the same municipality. The integral albedo coefficient at the zenith for the urban station was found to be almost twice that for suburban and rural stations. The zero-displacement height of the urban site was strongly dependent on wind direction, with values varying between 12.0 and 17.8 m, while the roughness length (≈1.5 m) was almost independent of upwind direction, but it was significantly higher than the typical values calculated for rural stations (≈0.4 m). The apparent thermal capacities and thermal conductivity at all the non-urban sites were in fair agreement with each other and typical of soils with relatively low water content, as expected for a relatively dry Mediterranean area like Rome, while the apparent thermal diffusivity reflected the presence of different soil types.

For environmental odor nuisance, it is extremely important to identify the instantaneous concentration statistics. In this work, a Fluctuating Plume Model for different statistical moments is proposed. It provides data in terms of mean concentrations, variance, and intensity of concentration. The 90th percentile peak-to-mean factor, R₉₀, was tested here by comparing it with the experimental results (Uttenweiler field experiment), considering different Probability Distribution Functions (PDFs): Gamma and the Modified Weibull. Seventy-two percent of the simulated mean concentration values fell within a factor 2 compared to the experimental ones: the model was judged acceptable. Both the modelled results for standard deviation, σ_C, and concentration intensity, I_c, overestimate the experimental data. This evidence can be due to the non-ideality of the measurement system. The propagation of those errors to the estimation of R₉₀ is complex, but the ranges covered are quite repeatable: the obtained values are 1–3 for the Gamma, 1.5–4 for Modified Weibull PDF, and experimental ones from 1.4 to 3.6.