This paper presents the design and implementation of a high sensitivity giant magnetoresistance (GMR) based current sensor with a broad range of applications. The novelty of our approach consists in using a double differential measurement system, based on commercial GMR sensors, with an adjustable biasing system used to linearize the field response of the system. The work aims to act as a fully-operational proof of concept application, with an emphasis on the mode of operation and methods to improve the sensitivity and linearity of the measurement system. The implemented system has a broad current measurement range from as low as 75 mA in DC and 150 mA in AC up to 4 A by using a single setup. The sensor system is also very low power, consuming only 6.4 mW. Due to the way the sensors are polarized and positioned above the U-shaped conductive band through which the current to be measured is flowing, the differential setup offers a sensitivity of about between 0.0272 to 0.0307 V/A (signal from sensors with no amplifications), a high immunity to external magnetic fields, low hysteresis effects of 40 mA, and a temperature drift of the offset of about −2.59×10⁻⁴ A/°C. The system provides a high flexibility in designing applications where local fields with very low amplitudes must be detected. This setup can be redesigned for a wide range of applications, thus allowing further specific optimizations, which would provide an even greater accuracy and a significantly extended operation range.

The conditions of field and voltage for inducing steady state excitations in fully perpendicular magnetic tunnel junctions (pMTJs), adapted for memory applications, were numerically investigated by the resolution of the Landau-Lifshitz-Gilbert equation in the macrospin approach. Both damping-like and the field-like spin transfer torque terms were taken into account in the simulations, as well as the contribution of the second order uniaxial anisotropy term (K₂), which has been recently revealed in MgO-based pMTJs. An in-plane applied magnetic field balances the out of plane symmetry of the pMTJ and allows the signal detection. Using this model, we assessed the states of the free layer magnetization as a function of strength of K₂ and polar θ_H angle of the applied field (varied from 90° to 60°). There are two stable states, with the magnetization in-plane or out of plane of the layer, and two dynamic states with self-sustained oscillations, called in-plane precession state (IPP) or out of plane precession state (OPP). The IPP mode, with oscillation frequencies up to 7 GHz, appears only for positive voltages if θ_H = 90°. However, it shows a more complex distribution when the field is slightly tilted out of plane. The OPP mode is excited only if K₂ is considered and reaches a maximum oscillation frequency of 15 GHz. Large areas of dynamic states with high frequencies are obtained for strong values of the field-like torque and K₂, when applying a slightly tilted external field toward the out of plane direction. The non-zero temperature does not modify the phase diagrams but reduces drastically the power spectral density peak amplitudes.