In this work, an innovative cellulose-based superabsorbent polymer (SAP) was experimentally assessed as an environmentally friendly alternative to acrylate-based SAPs, for the optimization of water consumption in agriculture. The cellulose-based SAP was synthesized and tested for its swelling capability in different aqueous media. The effectiveness of the SAP in agricultural applications was then evaluated by analyzing its performance after several absorption/desorption cycles, over a period of approximately 80 days, upon addition to different types of soil, i.e., white and red soil, for the cultivation of two varieties of plants typical of the Mediterranean area (tomatoes and chicory). The results confirmed that SAP-amended soil can store a considerable amount of water and can release it gradually to the plant roots when needed. The adoption of the proposed SAP in cultivations could thus represent a promising solution for the rationalization of water resources, especially in desert areas.

In most water distribution systems, a fairly sizable amount of water is lost because of leaks and faults in pipes. For this reason, the individuation of leaks is extremely important for the optimization and rationalization of water resources. However, the techniques and methodologies that are currently used for the individuation of leaks, despite being universally accepted, are extremely time-consuming and require highly-experienced personnel. Additionally, such techniques become unreliable and ineffective when the measurements are not performed in specific operating conditions of the pipe (e.g., high water pressure). On this basis, in this paper, a time domain reflectometry (TDR)-based system for the non-invasive detection of leaks in underground metal pipes is presented. Not only does the adoption of the developed system leads to accurately pinpoint the leak, but it also allows to dramatically reduce the required inspection times. The TDR-based system for leak detection is described in detail (with particular attention to the measurement principle behind the method and to the methodology). Furthermore, a strategy for enhancing the accuracy in pinpointing the leak is addressed. The proposed system is validated through experimental campaign that consisted in carrying out a leak-detection survey through the traditional methods and through the proposed method.

In this paper, a time domain reflectometry (TDR)-based system for measuring water content of raw construction materials is presented. The proposed system relies on the fact that the presence of water leads to an increase of the dielectric permittivity of materials; therefore, from TDR-based permittivity measurements, it is possible to infer the water content value. In practical applications, the proposed system could be used for assessing the intrinsic water content of construction materials before they are poured into the concrete mixture. Knowing the intrinsic water content of the raw materials, in fact, would allow to evaluate the optimal amount of water that should be added to the mixture in order to achieve the desired water-to-cement ratio. This, in turn, would permit to fine-tune and control the mechanical properties of the final concrete structures. For assessing the feasibility of using the proposed system for the intended purpose, water content measurements were carried out on three construction materials, namely, sand, gray cement, and white portland cement. For each of these materials, a calibration curve relating water content to the apparent dielectric permittivity was derived; additionally, through repeated measurements, also a confidence interval was associated with the calibration curves.