Geir Ersland

Prof. Geir Ersland

Department of Physics and Technology, University of Bergen, 5007 Bergen, Norway

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2020 in Energies
Verified
Journal Article
Open access
PDF file
JGJarand Gauteplass
Jarand Gauteplass
SAStian Almenningen
Stian Almenningen
TBTanja Barth
Tanja Barth
Geir ErslandGeir Ersland
Geir Ersland
Successful geological sequestration of carbon depends strongly on reservoir seal integrity and storage capacity, including CO2 injection efficiency. Formation of solid hydrates in the near-wellbore area during CO2 injection can cause permeability impairment and, eventually, injectivity loss. In this study, flow remediation in hydrate-plugged sandstone was assessed as function of hydrate morphology and saturation. CO2 and CH4 hydrates formed consistently at elevated pressures and low temperatures, reflecting gas-invaded zones containing residual brine near the injection well. Flow remediation by methanol injection benefited from miscibility with water; the methanol solution contacted and dissociated CO2 hydrates via liquid water channels. Injection of N2 gas did not result in flow remediation of non-porous CO2 and CH4 hydrates, likely due to insufficient gas permeability. In contrast, N2 as a thermodynamic inhibitor dissociated porous CH4 hydrates at lower hydrate saturations (<0.48 frac.). Core-scale thermal stimulation proved to be the most efficient remediation method for near-zero permeability conditions. However, once thermal stimulation ended and pure CO2 injection recommenced at hydrate-forming conditions, secondary hydrate formation occurred aggressively due to the memory effect. Field-specific remediation methods must be included in the well design to avoid key operational challenges during carbon injection and storage.

3 March 2020 in Minerals
Verified
Journal Article
Open access
PDF file
SAStian Almenningen
Stian Almenningen
SRSrikumar Roy
Srikumar Roy
AHArif Hussain
Arif Hussain
JSJohn Georg Seland
John Georg Seland
Geir ErslandGeir Ersland
Geir Ersland
In this paper, we investigate the effect of magnetic field strength on the transverse relaxation time constant (T2) in six distinct core plugs from four different rock types (three sandstones, one basalt, one volcanic tuff and one siltstone), retrieved from offshore Ireland. The CPMG pulse-sequence was used at two different magnetic field strengths: high-field at 4.70 T and low-field at 0.28 T. Axial images of the core plugs were also acquired with the RAREst sequence at high magnetic field strength. Thin-sections of the core plugs were prepared for optical imaging and SEM analysis, and provided qualitative information on the porosity and quantification of the elemental composition of the rock material. The content of iron varied from 4 wt. % to close to zero in the rock samples. Nevertheless, the effective T2 distributions obtained at low-field were used to successfully predict the porosity of the core plugs. Severe signal attenuations from internal magnetic gradients resulted in an underestimation of the porosity at high-field. No definitive trend was identified on the evolution of discrete relaxation time components between magnetic field strengths. The low-field measurements demonstrate that NMR is a powerful quantitative tool for petrophysical rock analysis as compared to thin-section analysis. The results of this study are of interest to the research community who characterizes natural gas hydrates in tight heterogeneous core plugs, and who typically relies on MR imaging to distinguish between solid hydrates and fluid phases. It further exemplifies the importance of selecting appropriate magnetic field strengths when employing NMR/MRI for porosity calculation in tight rock.

22 August 2019 in Energies
Verified
Journal Article
Open access
PDF file
SAStian Almenningen
Stian Almenningen
PFPer Fotland
Per Fotland
Geir ErslandGeir Ersland
Geir Ersland
This paper reports formation and dissociation patterns of methane hydrate in sandstone. Magnetic resonance imaging spatially resolved hydrate growth patterns and liberation of water during dissociation. A stacked core set-up using Bentheim sandstone with dual water saturation was designed to investigate the effect of initial water saturation on hydrate phase transitions. The growth of methane hydrate (P = 8.3 MPa, T = 1–3 °C) was more prominent in high water saturation regions and resulted in a heterogeneous hydrate saturation controlled by the initial water distribution. The change in transverse relaxation time constant, T2, was spatially mapped during growth and showed different response depending on the initial water saturation. T2 decreased significantly during growth in high water saturation regions and remained unchanged during growth in low water saturation regions. Pressure depletion from one end of the core induced a hydrate dissociation front starting at the depletion side and moving through the core as production continued. The final saturation of water after hydrate dissociation was more uniform than the initial water saturation, demonstrating the significant redistribution of water that will take place during methane gas production from a hydrate reservoir.