The gas turbines are highly demanded in modern industries, and the improvement of the performance derives from the increase of the turbine inlet temperature. Various cooling structures are used, such as ribs, pin fins, to improve heat transfer performance and extend the lifespan of the blade. Due to the limitations of the measurement technique, magnified geometry models have been tested with similarity theory in the past. In this paper, a thermochromic liquid crystal experiment was conducted to investigate the heat transfer performance of a magnified rectangular channel with ribs, supplemented with numerical simulation. The results indicated that the vortex and secondary flow generated by the ribs enhance the local heat transfer. Moreover, the thermal performance of the rib-roughed rectangular cooling channel was calculated under different scale factor conditions. The quantitative correlation equations of Nusselt number and friction coefficient versus the scale factor were established. Nusselt number showed an exponential growth with the increase of scale factor, while the friction coefficient displayed an exponential decay. Compared with the baseline, the enhanced heat transfer coefficient is improved by 18.7% and the normalized friction coefficient is dropped by 8.2% with geometry scaled up 10 times.
In today’s era of heightened environmental awareness, industries and means of transport are under increasing pressure to minimize their ecological footprint. In particular, small-scale power plants for the marine sector pose environmental challenges due to their pollutant emissions. One promising technology to address this purpose is represented by small-scale gas turbines. In this work, the design of a radial turbine and a centrifugal compressor for a 5 MW engine to be employed onboard ships is developed. After a one-dimensional design, the project involves the aerodynamic and structural design optimization of the two machines using fluid dynamic and structural simulation software. The final configuration obtained by the optimization process and its performance are analyzed, demonstrating that the use of a radial architecture for the construction of a 5 MW small gas-turbine assembly for marine propulsion is feasible. Both the compressor and the turbine optimization procedures led to final values of polytropic efficiencies that were three percentage points larger than the first-guess design machine values, simultaneously allowing for reductions in stress usage factors by more than 38% and 32% for the compressor and the turbine, respectively.
In order to solve the problem of insufficient thrust measurement accuracy of aeroengine indoor testbed, the thrust calibration experiment technology is studied. Form two aspects of engine static calibration and dynamic calibration, the mechanism of thrust calibration is comprehensively analyzed form the perspective of testbed and engine, and a complete set of operable test specifications is formed. The technical difficulties of engine consistency, inlet temperature deviation and non-standard weather are solved, and the accuracy of thrust transmission process is ensured. The test scheme of indoor test bed calibration is given, and the corresponding ideas and requirements are given according to the test conditions, test bench, calibration engine, test process and result analysis, to ensure the accuracy of calibration results.