This study underscores the profound influence of rock joints, both persistent and non-persistent with rock bridges, on the stability and behavior of rock masses—a critical consideration for sustainable engineering and natural structures, especially in rock slope stability. Leveraging the lattice spring-based synthetic rock mass (LS-SRM) modeling approach, this research aims to understand the impact of persistent and non-persistent joint parameters on rock slope stability. The Slope Model, a Synthetic Rock Mass (SRM) approach-based code, is used to investigate the joint parameters such as dip angle, spacing, rock bridge length, and trace overlapping. The results show that the mobilizing zones in slopes with non-persistent joints were smaller and shallower compared to slopes with fully persistent joints. The joint dip angle was found to heavily influence the failure mode in rock slopes with non-coplanar rock bridges. Shallow joint dip angles led to tensile failures, whereas steeper joint dip angles resulted in shear-tensile failures. Slopes with wider joint spacings exhibited deeper failure zones and a higher factor of safety, while longer rock bridge lengths enhanced slope stability and led to lower failure zones. The overlapping of joint traces has no apparent impact on slope stability and failure mechanism. This comprehensive analysis contributes valuable insights into sustainable rock engineering practices and the design of resilient structures in natural environments.

Brillouin scattering-based distributed fiber optic sensing (DFOS) technologies such as Brillouin optical time domain reflectometry (BOTDR) and Brillouin optical time domain analysis (BOTDA) have broad applicability for the long term and real-time monitoring of large concrete structures, underground mine excavations, pit slopes, and deep subsurface wellbores. When installed in brittle media, however, the meter scale spatial resolution of the BOTDR/A technology prohibits the detection or measurement of highly localized deformations, such as those which form at or along cracks, faults, and other discontinuities. This work presents a novel hybrid fiber optic cable with the ability to self-anchor to any brittle installation media without the need for manual installation along fixed interval points. Laboratory scale testing demonstrates the ability of the hybrid fiber optic cable to measure strains across highly localized deformation zones in both tension and shear. In addition, results show the applicability of the developed technology for strain monitoring in high displacement environments. Linear relationships are proposed for use in estimating the displacement magnitude along discontinuities in brittle media from strain signals collected from the hybrid fiber optic cable. The hybrid fiber optic cable has broad potential applications, such as geomechanical monitoring in underground mines, surface pits, large civil infrastructure projects, and deep subsurface wellbores. The benefits of fiber optic sensing, such as the intrinsic safety of the sensors, the long sensing range, and real time capabilities make this a compelling technique for long term structural health monitoring (SHM) in a wide range of industrial and civil applications.