Rice and quinoa starch esters were prepared by acylation using short-chain fatty acid anhydrides with different chain lengths (acetic, propionic, and butyric anhydride). A direct stoichiometric method based on the acylation reaction was used to determine the degree of substitution (DS) and acyl content (AC). In addition, Fourier-transform infrared spectroscopy (FTIR) was used to validate the conformational changes of acylated starch and ¹H-NMR was used as a DS reference method. DS by stoichiometric calculation was shown to be in agreement with FTIR and was comparable with DS obtained from Proton nuclear magnetic resonance (¹H-NMR). Based on this study, stoichiometric calculation allows rapid and direct determination of substitution levels and acyl content without the loss of samples, which provides efficiency and optimization of manufacturing procedures in producing the desired level of esterified starches.

Deep-fat frying is an important process used worldwide for the preparation of foods. Due to oxidation, hydrolysis, decomposition and oligomerization, numerous polar compounds are formed. These compounds change the physical, nutritional and sensory properties of the oil or fat. The standard methods of the German Society for Fat Science for the assessment of the quality of frying fats are time consuming and cost intensive. Therefore, alternative cost-effective and sensitive rapid methods, which ideally allow the quantitative determination of the quality of frying fats “in-line” in the deep-frying pan are needed. Sunflower oil and palm fat were thermally and oxidatively degraded in a beaker at atmospheric pressure under intensive stirring for 76 h at 175 °C. To evaluate the development of the physical properties during heat treatment, the viscosity and dielectric constant of these oils were measured. The temperature in a deep-frying pan can vary within a wide range (160–190 °C), and the viscosity and dielectric constant show a strong temperature dependence. Therefore, it was necessary to measure the temperature dependence of the viscosity and dielectric constant of the different degraded oils. Additionally, their chemical properties were characterized by high-performance gel permeation chromatography and Fourier-transform infrared spectroscopy (FTIR). The determination of the dielectric constant, which is directly correlated with the concentration of polar compounds, seems to be the best method for the assessment of the quality of used frying oils.

The bran accounts for approximately 25% of the wheat kernel but is currently only a by-product, used as animal feed. However, due to its high arabinoxylan content it could be a valuable raw material for food production. Arabinoxylans cannot be digested in the human intestine but are intensely studied for their health-beneficial properties. These include glycemic control by formation of a highly viscous gel in the intestine, and hence delaying starch digestion, alongside an increase in short chain fatty acids. To apply sufficient amounts of arabinoxylan for health-beneficial effects, extraction and concentration is required. Alkaline/oxidative conditions are commonly used, but for potential food applications more cost-efficient methods, without hazardous chemicals, are required. Therefore, this study aimed to optimize the conditions for hydrothermal extraction (extraction time and temperature) at laboratory-scale and to compare the results to an established alkaline/oxidative method. The resulting extracts were characterized for yield, purity, arabinoxylan molecular mass, arabinose/xylose ratio, and viscosity to evaluate the quality of the method. For the hydrothermal extraction, an extraction time of 1 h at 160 °C and 6.5 bar gave the best results. However, even these optimized conditions resulted in lower extract purity and severely degraded arabinoxylans. Although further optimization of the hydrothermal process is required, the present work builds an important foundation for the development of an industrial hydrothermal extraction method.