Philipp Röse

Dr. Philipp Röse

orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 November 2014 in Nature
Verified
Journal Article
Closed access
HHHaohua Huo
Haohua Huo
XSXiaodong Shen
Xiaodong Shen
CWChuanyong Wang
Chuanyong Wang
LZLilu Zhang
Lilu Zhang
PRPhilipp Röse
Philipp Röse
EMEric Meggers
Eric Meggers

12 July 2021 in ACS Catalysis
Verified
Journal Article
Open access
DEDaniel Escalera-López
Daniel Escalera-López
SCSteffen Czioska
Steffen Czioska
JGJanis Geppert
Janis Geppert
ABAlexey Boubnov
Alexey Boubnov
PRPhilipp Röse
Philipp Röse
SCSerhiy Cherevko
Serhiy Cherevko
The increasing scarcity of iridium (Ir) and its rutile-type oxide (IrO2), the current state-of-the-art oxygen evolution reaction (OER) catalysts, is driving the transition toward the use of mixed Ir oxides with a highly active yet inexpensive metal (IrxM1–xO2). Ruthenium (Ru) has been commonly employed due to its high OER activity although its electrochemical stability in Ir-Ru mixed oxide nanoparticles (IrxRu1–xO2 NPs), especially at high relative contents, is rarely evaluated for long-term application as water electrolyzers. In this work, we bridge the knowledge gap by performing a thorough study on the composition- and phase-dependent stability of well-defined IrxRu1–xO2 NPs prepared by flame spray pyrolysis under dynamic operating conditions. As-prepared NPs (IrxRu1–xOy) present an amorphous coral-like structure with a hydrous Ir-Ru oxide phase, which upon post-synthetic thermal treatment fully converts to a rutile-type structure followed by a selective Ir enrichment at the NP topmost surface. It was demonstrated that Ir incorporation into a RuO2 matrix drastically reduced Ru dissolution by ca. 10-fold at the expense of worsening Ir inherent stability, regardless of the oxide phase present. Hydrous IrxRu1–xOy NPs, however, were shown to be 1000-fold less stable than rutile-type IrxRu1–xO2, where the severe Ru leaching yielded a fast convergence toward the activity of monometallic hydrous IrOy. For rutile-type IrxRu1–xO2, the sequential start-up/shut-down OER protocol employed revealed a steady-state dissolution for both Ir and Ru, as well as the key role of surface Ru species in OER activity: minimal Ru surface losses (<1 at. %) yielded OER activities for tested Ir0.2Ru0.8O2 equivalent to those of untested Ir0.8Ru0.2O2. Ir enrichment at the NP topmost surface, which mitigates selective subsurface Ru dissolution, is identified as the origin of the NP stabilization. These results suggest Ru-rich IrxRu1–xO2 NPs to be viable electrocatalysts for long-term water electrolysis, with significant repercussions in cost reduction.

29 July 2021 in ACS Catalysis
Verified
Journal Article
Open access
SCSteffen Czioska
Steffen Czioska
ABAlexey Boubnov
Alexey Boubnov
DEDaniel Escalera-López
Daniel Escalera-López
JGJanis Geppert
Janis Geppert
AZAlexandra Zagalskaya
Alexandra Zagalskaya
Jan-Dierk GrunwaldtJan-Dierk Grunwaldt
Jan-Dierk Grunwaldt
The structure of IrO2 during the oxygen evolution reaction (OER) was studied by operando X-ray absorption spectroscopy (XAS) at the Ir L3-edge to gain insight into the processes that occur during the electrocatalytic reaction at the anode during water electrolysis. For this purpose, calcined and uncalcined IrO2 nanoparticles were tested in an operando spectroelectrochemical cell. In situ XAS under different applied potentials uncovered strong structural changes when changing the potential. Modulation excitation spectroscopy combined with XAS enhanced the information on the dynamic changes significantly. Principal component analysis (PCA) of the resulting spectra as well as FEFF9 calculations uncovered that both the Ir L3-edge energy and the white line intensity changed due to the formation of oxygen vacancies and lower oxidation state of iridium at higher potentials, respectively. The deconvoluted spectra and their components lead to two different OER modes. It was observed that at higher OER potentials, the well-known OER mechanisms need to be modified, which is also associated with the stabilization of the catalyst, as confirmed by in situ inductively coupled plasma mass spectrometry (ICP-MS). At these elevated OER potentials above 1.5 V, stronger Ir–Ir interactions were observed. They were more dominant in the calcined IrO2 samples than in the uncalcined ones. The stronger Ir–Ir interaction upon vacancy formation is also supported by theoretical studies. We propose that this may be a crucial factor in the increased dissolution stability of the IrO2 catalyst after calcination. The results presented here provide additional insights into the OER in acid media and demonstrate a powerful technique for quantifying the differences in mechanisms on different OER electrocatalysts. Furthermore, insights into the OER at a fundamental level are provided, which will contribute to further understanding of the reaction mechanisms in water electrolysis.

1 April 2015 in Chemistry – A European Journal
Verified
Journal Article
Closed access
PDF file
CWChuanyong Wang
Chuanyong Wang
YZYu Zheng
Yu Zheng
HHHaohua Huo
Haohua Huo
PRPhilipp Röse
Philipp Röse
LZLilu Zhang
Lilu Zhang
EMEric Meggers
Eric Meggers

18 July 2022 in Journal of the American Chemical Society
Verified
Journal Article
Open access
JGJanis Geppert
Janis Geppert
PRPhilipp Röse
Philipp Röse
SCSteffen Czioska
Steffen Czioska
DEDaniel Escalera-López
Daniel Escalera-López
ABAlexey Boubnov
Alexey Boubnov
UKUlrike Krewer
Ulrike Krewer
The microkinetics of the electrocatalytic oxygen evolution reaction substantially determines the performance in proton-exchange membrane water electrolysis. State-of-the-art nanoparticulated rutile IrO2 electrocatalysts present an excellent trade-off between activity and stability due to the efficient formation of intermediate surface species. To reveal and analyze the interaction of individual surface processes, a detailed dynamic microkinetic model approach is established and validated using cyclic voltammetry. We show that the interaction of three different processes, which are the adsorption of water, one potential-driven deprotonation step, and the detachment of oxygen, limits the overall reaction turnover. During the reaction, the active IrO2 surface is covered mainly by *O, *OOH, and *OO adsorbed species with a share dependent on the applied potential and of 44, 28, and 20% at an overpotential of 350 mV, respectively. In contrast to state-of-the-art calculations of ideal catalyst surfaces, this novel model-based methodology allows for experimental identification of the microkinetics as well as thermodynamic energy values of real pristine and degraded nanoparticles. We show that the loss in electrocatalytic activity during degradation is correlated to an increase in the activation energy of deprotonation processes, whereas reaction energies were marginally affected. As the effect of electrolyte-related parameters does not cause such a decrease, the model-based analysis demonstrates that material changes trigger the performance loss. These insights into the degradation of IrO2 and its effect on the surface processes provide the basis for a deeper understanding of degrading active sites for the optimization of the oxygen evolution performance.

9 May 2023 in Angewandte Chemie International Edition
Verified
Journal Article
Open access
Mariya E. IvanovaMariya E. Ivanova
Mariya E. Ivanova
RPRalf Peters
Ralf Peters
MMMartin Müller
Martin Müller
SHStefan Haas
Stefan Haas
MSMartin Florian Seidler
Martin Florian Seidler
OGOlivier Guillon
Olivier Guillon
Hydrogen (H2) produced from renewables will have a growing impact on the global energy dynamics towards sustainable and carbon‐neutral standards. The share of green H2 is still too low to meet the net‐zero target, while the demand for high‐quality hydrogen continues to rise. These factors amplify the need for economically viable H2 generation technologies. The present article aims at evaluating the existing technologies for high‐quality H2 production based on solar energy. Technologies such as water electrolysis, photoelectrochemical and solar thermochemical water splitting, liquid metal reactors and plasma conversion utilize solar power directly or indirectly (as carbon‐neutral electrons) and are reviewed from the perspective of their current development level, technical limitations and future potential.