13 October 2021 in Advanced Energy Materials
Proton‐exchange membrane water electrolyzers (PEMWEs) will play a key role in future sustainable hydrogen production for mobility, households or chemical industry. Yet, the anode in PEMWEs, where the pivotal oxygen evolution reaction takes place, needs further improvement in terms of performance and cost. Both catalyst materials and electrode structure have to be optimized in order to inhibit degradation and reduce noble metal loadings. This review focuses on a holistic approach, covering all catalyst material, electrode structure, and transport layers within the framework of an overall electrode design, which not only optimizes the catalyst but also, all components of the electrode in conjunction. This review defines the goals for performance metrics of future PEMWEs in terms of power density and durability of the anode. Moreover, it summarizes manufacturing techniques and approaches that have a chance to be upscaled to meet the megawatt deployment of PEMWEs. The different aspects described jointly in this review such as novel catalyst system with higher intrinsic and structural performance or graded porous transport layers shall help to advance a next generation of electrodes.
1 July 2020 in Applied Catalysis B: Environment and Energy
12 July 2021 in ACS Catalysis
The increasing scarcity of iridium (Ir) and its rutile-type oxide (IrO2), the current state-of-the-art oxygen evolution reaction (OER) catalysts, is driving the transition toward the use of mixed Ir oxides with a highly active yet inexpensive metal (IrxM1–xO2). Ruthenium (Ru) has been commonly employed due to its high OER activity although its electrochemical stability in Ir-Ru mixed oxide nanoparticles (IrxRu1–xO2 NPs), especially at high relative contents, is rarely evaluated for long-term application as water electrolyzers. In this work, we bridge the knowledge gap by performing a thorough study on the composition- and phase-dependent stability of well-defined IrxRu1–xO2 NPs prepared by flame spray pyrolysis under dynamic operating conditions. As-prepared NPs (IrxRu1–xOy) present an amorphous coral-like structure with a hydrous Ir-Ru oxide phase, which upon post-synthetic thermal treatment fully converts to a rutile-type structure followed by a selective Ir enrichment at the NP topmost surface. It was demonstrated that Ir incorporation into a RuO2 matrix drastically reduced Ru dissolution by ca. 10-fold at the expense of worsening Ir inherent stability, regardless of the oxide phase present. Hydrous IrxRu1–xOy NPs, however, were shown to be 1000-fold less stable than rutile-type IrxRu1–xO2, where the severe Ru leaching yielded a fast convergence toward the activity of monometallic hydrous IrOy. For rutile-type IrxRu1–xO2, the sequential start-up/shut-down OER protocol employed revealed a steady-state dissolution for both Ir and Ru, as well as the key role of surface Ru species in OER activity: minimal Ru surface losses (<1 at. %) yielded OER activities for tested Ir0.2Ru0.8O2 equivalent to those of untested Ir0.8Ru0.2O2. Ir enrichment at the NP topmost surface, which mitigates selective subsurface Ru dissolution, is identified as the origin of the NP stabilization. These results suggest Ru-rich IrxRu1–xO2 NPs to be viable electrocatalysts for long-term water electrolysis, with significant repercussions in cost reduction.
29 July 2021 in ACS Catalysis
The structure of IrO2 during the oxygen evolution reaction (OER) was studied by operando X-ray absorption spectroscopy (XAS) at the Ir L3-edge to gain insight into the processes that occur during the electrocatalytic reaction at the anode during water electrolysis. For this purpose, calcined and uncalcined IrO2 nanoparticles were tested in an operando spectroelectrochemical cell. In situ XAS under different applied potentials uncovered strong structural changes when changing the potential. Modulation excitation spectroscopy combined with XAS enhanced the information on the dynamic changes significantly. Principal component analysis (PCA) of the resulting spectra as well as FEFF9 calculations uncovered that both the Ir L3-edge energy and the white line intensity changed due to the formation of oxygen vacancies and lower oxidation state of iridium at higher potentials, respectively. The deconvoluted spectra and their components lead to two different OER modes. It was observed that at higher OER potentials, the well-known OER mechanisms need to be modified, which is also associated with the stabilization of the catalyst, as confirmed by in situ inductively coupled plasma mass spectrometry (ICP-MS). At these elevated OER potentials above 1.5 V, stronger Ir–Ir interactions were observed. They were more dominant in the calcined IrO2 samples than in the uncalcined ones. The stronger Ir–Ir interaction upon vacancy formation is also supported by theoretical studies. We propose that this may be a crucial factor in the increased dissolution stability of the IrO2 catalyst after calcination. The results presented here provide additional insights into the OER in acid media and demonstrate a powerful technique for quantifying the differences in mechanisms on different OER electrocatalysts. Furthermore, insights into the OER at a fundamental level are provided, which will contribute to further understanding of the reaction mechanisms in water electrolysis.
11 August 2016 in ACS Catalysis
This report focuses on a novel strategy for the preparation of transition metal-MoS2 hybrid nanoclusters based on a one step, dual-target magnetron sputtering and gas condensation process demonstrated for Ni-MoS2. Aberration-corrected STEM images coupled with EDX analysis confirms the presence of Ni and MoS2 in the hybrid nanoclusters (average diameter= 5.0 nm, Mo:S ratio 1:1.8±0.1). The Ni-MoS2 nanoclusters display a 100 mV shift in the hydrogen evolution reaction (HER) onset potential and an almost 3-fold increase in exchange current density compared with the undoped MoS2 nanoclusters, the latter effect in agreement with reported DFT calculations. This activity is only reached after air exposure of the Ni-MoS2 hybrid nanoclusters, suggested by XPS measurements to originate from a Ni dopant atoms oxidation state conversion from metallic to 2+ characteristic of the NiO species active to the HER. Anodic stripping voltammetry (ASV) experiments on the Ni-MoS2 hybrid nanoclusters confirm the presence of Ni-doped edge sites and reveal distinctive electrochemical features associated with both doped Mo-edge and doped S-edge sites which correlate with both their thermodynamic stability and relative abundance.
11 November 2024 in Journal of the American Chemical Society
Reducing the iridium demand in Proton Exchange Membrane Water Electrolyzers (PEM WE) is a critical priority for the green hydrogen industry. This study reports the discovery of a TiO2-supported Ir@IrO(OH)x core-shell nanoparticle catalyst with reduced Ir content, which exhibits superior catalytic performance for the electrochemical oxygen evolution reaction (OER) compared to a commercial reference. The TiO2-supported Ir@IrO(OH)x core-shell nanoparticle configuration significantly enhances the OER Ir mass activity from 8 to approximately 150 A gIr-1 at 1.53 VRHE while reducing the iridium packing density from 1.6 to below 0.77 gIr cm-3. These advancements allow for viable anode layer thicknesses with lower Ir loading, reducing iridium utilization at 70% LHV from 0.42 to 0.075 gIr kW-1 compared to commercial IrO2/TiO2. The identification of the Ir@IrO(OH)x/TiO2 OER catalyst resulted from extensive HAADF-EDX microscopic analysis, operando XAS, and online ICP-MS analysis of 30-80 wt % Ir/TiO2 materials. These analyses established correlations among Ir weight loading, electrode electrical conductivity, electrochemical stability, and Ir mass-based OER activity. The activated Ir@IrO(OH)x/TiO2 catalyst-support system demonstrated an exceptionally stable morphology of supported core-shell particles, suggesting strong catalyst-support interactions (CSIs) between nanoparticles and crystalline oxide facets. Operando XAS analysis revealed the reversible evolution of significantly contracted Ir-O bond motifs with enhanced covalent character, conducive to the formation of catalytically active electrophilic OI- ligand species. These findings indicate that atomic Ir surface dissolution generates Ir lattice vacancies, facilitating the emergence of electrophilic OI- species under OER conditions, while CSIs promote the reversible contraction of Ir-O distances, reforming electrophilic OI- and enhancing both catalytic activity and stability.