Nowcasting is an important technique for weather forecasting because sudden weather changes significantly affect human life. The encoding-forecasting model, which is a state-of-the-art architecture in the field of data-driven radar extrapolation, does not particularly focus on the latest data when forecasting natural phenomena. This paper proposes a weighted broadcasting method that emphasizes the latest data of the time step to improve the nowcasting performance. This weighted broadcasting method allows the most recent rainfall patterns to have a greater impact on the forecasting network by extending the architecture of the existing encoding-forecasting model. Experimental results show that the proposed model is 1.74% and 2.20% better than the existing encoding-forecasting model in terms of mean absolute error and critical success index, respectively. In the case of heavy rainfall with an intensity of 30 mm/h or higher, the proposed model was more than 30% superior to the existing encoding-forecasting model. Therefore, applying the weighted broadcasting method, which explicitly places a high emphasis on the latest information, to the encoding-forecasting model is considered as an improvement that is applicable to the state-of-the-art implementation of data-driven radar-based precipitation nowcasting.

Typhoons can often cause inundation in lower coastal cities by inducing strong surges and waves. Being affected by typhoon annually, the coastal cities in South Korea are very vulnerable to typhoons. In 2016, a typhoon ‘CHABA’, with a maximum 10 min sustained wind speed of about 50 m/s and a minimum central pressure of 905 hPa, hit South Korea, suffering tremendous damage. In particular, ‘CHABA’-induced coastal inundation resulted in serious damage to the coastal area of Busan where a lot of high-rise buildings and residential areas are concentrated, and was caused by the combined effect of tide, surge, and wave. The typhoon-induced surge raised sea levels during high tide, and the strong wave with a long period of more than 10 s eventually led to the coastal inundation at the same time. The present research focuses a numerical downscaling considering the effects of tide, surge and wave for coastal inundation induced by Typhoon ‘CHABA’. This downscaling approach applied several numerical models, which are the Weather Research and Forecasting model (WRF) for typhoon simulation, the Finite Volume Community Ocean Model (FVCOM) for tide and surge simulation, and the Simulating WAve Nearshore (SWAN) for wave simulation. In a domain covering the Korean Peninsula, typhoon-induced surges and waves were simulated applying the results simulated by WRF as meteorological conditions. In the downscaled domain ranged near the coastal area of Busan, the coastal inundation was simulated blending a storm tide height and an irregular wave height obtained from the domain, in which each height has 1 s interval. The irregular wave height was calculated using the significant wave height and peak period. Through this downscaling study, the impact of storm tide and wave on coastal inundation was estimated.

The main goal of this study was comparing the performance of an open-source code OpenFOAM and a commercial software Ansys Fluent in simulating the turbulent flow through a scour hole developed in a sand bed channel, which helps to give a hint in choosing the appropriate calculating tool. Both models were set with the same mesh and as similar as possible numerical settings, with RANS turbulence modeling, applying the k-ωSST model, in transient simulations. The results of flow pattern, velocity, and turbulence properties were collected and compared with laboratory experimental data. The analyzed results showed that, although both of the two models cannot perfectly reproduce the values from a laboratory experiment, they can quite well capture the flow in scour hole near the wall, with a bit higher performance coming from the OpenFOAM model application.

The authors wish to make the following corrections to this paper