In this study, discrete element PFC3D software was used to simulate the uniaxial compression of C30 concrete specimen models after freezing–thawing damage. Based on the thickness of the freezing–thawing damage layer of the concrete and the uniaxial compression test, the meso-parameters of cement mortar in concrete and the meso-parameters of weak interface between the cement mortar and coarse aggregate under different freezing–thawing cycles were calibrated. The axial compression deformation produced in the experiment was compared with the axial displacement of particles obtained by numerical simulation to verify the accuracy of the model and the selected meso-parameters. Based on the numerical model, the effects of freeze–thaw damage on the mechanical properties of concrete were studied from the perspectives of the contact force between particles, crack development, and concrete cracking, and the characteristics of meso-scale failure of concrete model after freezing–thawing damage were analyzed. The results show that the stress–strain curves obtained by uniaxial compression simulation in the PFC3D-based numerical model of freezing–thawing concrete are consistent with the test results. During the uniaxial compression process in the freezing–thawing concrete model, the contact force at different stage points between the particles, crack development, and the number of cracked concrete fragments quantitatively reflected the degree of meso-scale concrete failure. With increasing numbers of freeze–thaw cycles, the failure severity of the model increased with obvious penetrating cracks, which is consistent with the failure pattern obtained by physical experiments. Therefore, numerical experiments can be used to study the meso-scale failure modes of concrete.
1 December 2022 in Journal of Building Engineering
The morphology and volume fraction of coarse aggregate particles significantly influence the mechanical characteristics of concrete. This paper presents the development of a numerical model for pebble concrete by combining experiments with the discrete element method. The mesoscopic parameters between mortars and the contact surface between mortars and aggregates in the model were calibrated by comparing simulated stress–strain relationships with experimental data from pebble concrete. Subsequently, the model and mesoscopic parameters were validated by comparing them with experimental results. The obtained mesoscopic parameters were then utilized in the numerical modeling of uniaxial compression for single-shaped coarse aggregate concrete. Results showed that the peak stress of the elliptical aggregate concrete was 2.8 MPa higher than that of the oblate spherical aggregate concrete, leading to more cracks and severe damage in the former. Thus, elliptical aggregates proved more suitable as coarse aggregates for concrete than oblate spherical aggregates. Furthermore, the study investigated the influence of ellipsoidal aggregate volume fraction on concrete strength. The compressive strength reached the highest when the volume fraction of ellipsoidal aggregate was 57%. Therefore, the ideal coarse aggregate volume fraction was determined to be 57%. These results offer valuable insights into designing concrete mix proportions.
10 May 2024 in International Journal of Civil Engineering
Mass concrete structures are prone to suffer temperature destruction during construction and operation because of their own mechanical properties and the role of cement hydration; therefore, the law of temperature field and temperature stress changes is crucial. This paper is based on the heat conduction theory and contact friction element theory under general external load. The heat conduction matrix, node thermal load vector, equivalent stiffness-constraint matrix and equivalent load vector of the contact friction element are each added to the whole heat conduction matrix, thermal load vector and total stiffness matrix, and the total load vector according to the finite element integration rule to establish the thermal-stress calculation model of the contact friction element. Combined with the Qi River inverted siphon project, this paper analyzed the temperature field and temperature stress using the three-dimensional finite element method, considering the changes of concrete thermodynamic parameters with age and the outside air temperature and other conditions, and obtained the distribution and variation in temperature field and temperature stress during the construction of an inverted siphon. The research results are of great significance for temperature control and crack prevention of inverted siphon structures. The thermal-stress calculation model of the contact friction element overcomes the limitations that it is difficult to use the current contact surface model to perform the temperature field simulation and further improves the application of the contact friction element model in the simulation of the temperature field and the temperature stress of mass concrete.