Joaquin Bernal Mendez

Dr. Joaquin Bernal Mendez

orcid

Research Focus & Metrics

Academic Career Length

30Years (1997-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 July 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Open access
CDC. Dominguez-Palacios
C. Dominguez-Palacios
JMJoaquin Bernal Mendez
Joaquin Bernal Mendez
MPM. M. Prats
M. M. Prats
In this paper, we present a technique to characterize common mode chokes at high frequencies that only requires a measurement, which can be performed with a spectrum analyzer with the tracking generator. This technique is based upon a theoretical modal analysis of the common mode choke as a four-ports device. This analysis demonstrates that the transmission coefficient measured for one of the windings of the common mode choke, while the other winding is open circuited will always show two minimums, which are associated with resonances involving currents flowing, respectively, in common mode and in differential mode in the common mode choke. Therefore, the response at high frequencies of the common mode choke to both a common mode and a differential mode stimulus can be foreseen from the measurement of this transmission coefficient. Moreover, from the analytical expressions obtained for the frequencies of resonance of the common mode choke in that configuration, we develop a method for obtaining the capacitive, resistive, and inductive parameters of a circuit model of the common mode choke. To validate the proposed technique different commercial common mode chokes have been measured and the predicted performance of the model has been compared with measured responses. We have verified that in all the cases the measured transmission coefficient exhibits the resonant behavior predicted by the theoretical analysis. We have checked that in most cases the method designed for extracting the high-frequency parameters of the circuit model of the common mode choke yields an accurate model of the device up to frequencies as high as 30-50 MHz. An exception are common mode chokes made of materials with an extreme variation of their properties with regards to frequency, such as nanocrystalline materials.

14 December 2016 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
FBFulya Bagci
Fulya Bagci
AFArmando Fernandez-Prieto
Armando Fernandez-Prieto
ALAintzane Lujambio
Aintzane Lujambio
Jesús MartelJesús Martel
Jesús Martel
JMJoaquin Bernal Mendez
Joaquin Bernal Mendez
FMFrancisco Medina
Francisco Medina
A new compact balanced dual-band bandpass filter based on coupled-embedded resonators with modified ground plane is presented in this work. Common-mode is rejected within the two differential passbands by symmetrically introducing four coupled U-shaped defected ground structures below the resonators. Common-mode rejection is significantly improved when compared with the standard (solid ground plane) filter with similar geometry thanks to the introduction of four extra transmission zeros. Due to the symmetry, the differential mode is not significantly affected by the presence of the U-shaped resonators. Circuit-model data, full-wave simulations and measurements are provided to verify the benefits of the proposed dual-band filter.

1 January 1997 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
JMJoaquin Bernal Mendez
Joaquin Bernal Mendez
FMF. Medina
F. Medina
MHM. Horno
M. Horno

9 April 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
PGPablo González-Vizuete
Pablo González-Vizuete
FFFranchesco Fico
Franchesco Fico
Armando Fernandez PrietoArmando Fernandez Prieto
Armando Fernandez Prieto
MFManuel J. Freire
Manuel J. Freire
JMJoaquin Bernal Mendez
Joaquin Bernal Mendez
This work presents a simple and accurate method for the calculation of both the self-inductance and the mutual inductance between thin-film capacitors, placed in close proximity in electromagnetic interference filters. From physical considerations regarding the impact of both skin and proximity effects, we approximate the currents flowing inside the capacitors at high frequencies by strip currents. This hypothesis is supported by electromagnetic simulations and measurements in this paper. On the basis of this model, we use analytical expressions to calculate both the self-inductance and the mutual inductance as a function of purely geometrical parameters such as the size of the capacitors, their orientation and the distances between them. Because no previous impedance or network parameters measurements are required to estimate these inductances, this technique is suitable for virtual prototyping design. We have constructed and measured several test boards to check the accuracy of the method and to identify its scope and limits. Also, in this work we employ this technique to study the applicability to thin-film capacitors of a design strategy originally conceived to reduce the negative effects of the inductive parasitics of surface-mount capacitors. We demonstrate that this design strategy significantly improves the attenuation provided by filters with thin-film capacitors at high frequencies.

1 March 2000 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
JMJoaquin Bernal Mendez
Joaquin Bernal Mendez
FMF. Medina
F. Medina
RBR.R. Boix
R.R. Boix
MHM. Horno
M. Horno

11 June 2019 in IEEE Transactions on Electromagnetic Compatibility
Verified
Journal Article
Closed access
CDCarlos Domínguez-Palacios
Carlos Domínguez-Palacios
PGPablo González-Vizuete
Pablo González-Vizuete
MPMaria Angeles Martin Prats
Maria Angeles Martin Prats
JMJoaquin Bernal Mendez
Joaquin Bernal Mendez
This work analyzes the effect of conducting bands placed close to a common mode choke on the attenuation provided by an electromagnetic interference filter where the common mode choke is mounted. The main aim was to determine whether the response of the common mode choke can be modified and to clearly identify and quantify the physical mechanism responsible for the changes found in the attenuation of the common mode choke and the electromagnetic interference filter. The impact of grounded and ungrounded conducting surfaces was studied for the two more typical configurations of common mode chokes: vertically and horizontally mounted. This study has allowed us to devise an optimum shield for a common mode choke that can significantly improve the attenuation to both common mode and differential mode noise of an electromagnetic interference filter at high frequencies, where parasitic effects usually undermine the performance of the filter. Key features of the technique described here are that it can be applied easily and that it does not result in an increase of the weight, volume, or cost of the filter.