Chaehyun Jo

Mr. Chaehyun Jo

Ph.D. Student

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 February 2020 in Polymers
Verified
Journal Article
Open access
PDF file
JLJinchang Liu
Jinchang Liu
HSHiroki Shimanoe
Hiroki Shimanoe
SKSeunghyun Ko
Seunghyun Ko
HLHansong Lee
Hansong Lee
CJChaehyun Jo
Chaehyun Jo
SYSeong-Ho Yoon
Seong-Ho Yoon
Pure, highly chlorinated polyvinyl chloride (CPVC), with a 63 wt % of chlorine, showed a unique-thermal-pyrolytic-phenomenon that meant it could be converted to carbon material through solid-phase carbonisation rather than liquid-phase carbonisation. The CPVC began to decompose at 270 °C, with a rapid loss in mass due to dehydrochlorination and novel aromatisation and polycondensation up to 400 °C. In this study, we attempted to prepare carbon fibre (CF) without oxidative stabilisation, using the aforementioned CPVC as a novel precursor. Through the processes of solution spinning and solid-state carbonisation, the spun CPVC fibre was directly converted to CF, with a carbonisation yield of 26.2 wt %. The CPVC-derived CF exhibited a relatively smooth surface; however, it still demonstrated a low mechanical performance. This was because the spun fibre was not stretched during the heat treatment. Tensile strength, Young’s modulus and elongation values of 590 ± 84 MPa, 50 ± 8 GPa, and 1.2 ± 0.2%, respectively, were obtained from the CPVC spun fibre, with an average diameter of 19.4 μm, following carbonisation at 1600 °C for 5 min.

18 April 2022 in Gels
Verified
Journal Article
Open access
PDF file
CJChaehyun Jo
Chaehyun Jo
SKSam Soo Kim
Sam Soo Kim
BRBalasubramanian Rukmanikrishnan
Balasubramanian Rukmanikrishnan
SRSrinivasan Ramalingam
Srinivasan Ramalingam
Prabakaran D.SPrabakaran D.S
Prabakaran D.S
JLJaewoong Lee
Jaewoong Lee
Cellulose pulp (CP), polyurethane (PU), and curcumin-based biocompatible composite films were prepared using a simple cost-effective method. Significant structural and microstructural changes were studied using FT-IR spectroscopy, XRD, and SEM. The 5% and 10% gravimetric losses of the CP/PU/curcumin composite were found to be in the range 87.2–182.3 °C and 166.7–249.8 °C, respectively. All the composites exhibited single Tg values in the range 147.4–154.2 °C. The tensile strength of CP was measured to be 93.2 MPa, which dropped to 14.1 MPa for the 1:0.5 CP/PU composite and then steadily increased to 30.5 MPa with further addition of PU. The elongation at the break of the composites decreased from 8.1 to 3.7% with the addition of PU. The addition of PU also improved the water vapor permeability (3.96 × 10−9 to 1.75 × 10−9 g m−1 s−1 Pa−1) and swelling ratio (285 to 202%) of the CP composite films. The CP/PU/curcumin composite exhibited good antioxidant activity and no cytotoxicity when tested on the HaCat cell line. The visual appearance and UV transmittance (86.2–32.9% at 600 nm) of the CP composite films were significantly altered by the incorporation of PU and curcumin. This study demonstrates that CP/PU/curcumin composites can be used for various packaging and biomedical applications.