Acoustic emission (AE) and microseismic (MS) monitoring technologies have been successfully applied to material performance analysis, material detection, building and rockmass structure stability, and for early warnings in civil engineering
We present a method for measuring absorption at the 1 × 10-5 cm-1 level in high-quality optical materials. Using a Shack-Hartmann wave-front detector, thermal lensing in these materials may be measured. Then, the absorption coefficient may be estimated by fitting the observed deformation to a thermal lensing model based on the temperature dependences of the refractive index and the thermal expansion coefficient. For a particular sample of fused silica, the absorption coefficient was determined to be 1.8 ± 0.4 × 10-5 cm-1. Obtaining this result requires a resolution in the optical path length better than ±0.1 nm.
9 June 2011 in The Journal of Strain Analysis for Engineering Design
As a scale-independent theory of deformation and fracture applicable to practical engineering problems, the field theoretical approach employed by physical mesomechanics is discussed in this paper. Being based on a fundamental physical principle known as gauge invariance, this approach does not rely on empirical concepts or phenomenology, and thereby is fundamentally scale independent. The derivation of physical-mesomechanical field equations is examined on a step-by-step basis, and the physical meaning of each step is clarified. Along the same line of argument, plastic deformation and transition to fracture is interpreted as an energy-dissipative process. Previously derived plastic deformation and fracture criteria are validated via detailed theoretical consideration and comparison with supporting experimental data.
Co-application of acoustoelasticity and optical interferometry to residual stress analysis is discussed. The underlying idea is to combine the advantages of both methods. Acoustoelasticity is capable of evaluating a residual stress absolutely but it is a single point measurement. Optical interferometry is able to measure deformation yielding two-dimensional, full-field data, but it is not suitable for absolute evaluation of residual stresses. By theoretically relating the deformation data to residual stresses, and calibrating it with absolute residual stress evaluated at a reference point, it is possible to measure residual stresses quantitatively, nondestructively and two-dimensionally. The feasibility of the idea has been tested with a butt-jointed dissimilar plate specimen. A steel plate 18.5 mm wide, 50 mm long and 3.37 mm thick is braze-jointed to a cemented carbide plate of the same dimension along the 18.5 mm-side. Acoustoelasticity evaluates the elastic modulus at reference points via acoustic velocity measurement. A tensile load is applied to the specimen at a constant pulling rate in a stress range substantially lower than the yield stress. Optical interferometry measures the resulting acceleration field. Based on the theory of harmonic oscillation, the acceleration field is correlated to compressive and tensile residual stresses qualitatively. The acoustic and optical results show reasonable agreement in the compressive and tensile residual stresses, indicating the feasibility of the idea.