This study presents the results of the biomass pyrolysis process focusing on biochar production and its potential energetic (as solid fuel) and material (as adsorbent) applications. Three kinds of biomass waste were investigated: wheat straw, spent coffee grounds, and brewery grains. The pyrolysis process was carried out under nitrogen atmosphere at 400 and 500 °C (residence time of 20 min). A significant increase in the carbon content was observed in the biochars, e.g., from 45% to 73% (at 400 °C) and 77% (at 500 °C) for spent coffee grounds. In addition, the structure and morphology were investigated using scanning electron microscopy. Thermal properties were studied using a simultaneous thermal analysis under an oxidising atmosphere. The chemical activation was completed using KOH. The sorption properties of the obtained biochars were tested using chromium ion (Cr3+) adsorption from liquid solution. The specific surface area and average pore diameter of each sample were determined using the BET method. Finally, it was found that selected biochars can be applied as adsorbent or a fuel. In detail, brewery grains-activated carbon had the highest surface area, wheat straw-activated carbon adsorbed the highest amount of Cr3+, and wheat straw chars presented the best combustion properties.
The presented work is focused on biomass thermochemical conversion with integrated CO2 capture. The main aim of this study was the in-depth investigation of the impact of pyrolysis temperature (500, 600 and 700 °C) and CaO sorbent addition on the chemical and physical properties of obtained char and syngas. Under the effect of the pyrolysis temperature, the properties of biomass chars were gradually changed, and this was confirmed by examination using thermal analysis, scanning electron microscopy, X-ray diffraction, and porosimetry methods. The chars were characterised by a noticeable carbon content (two times at 700 °C) resulting in a lower O/C ratio. The calculated combustion indexes indicated the better combustible properties of chars. In addition, structural morphology changes were observed. However, the increasing pyrolysis temperature resulted in changes of solid products; the differences of char properties were not significant in the range of 500 to 700 °C. Syngas was analysed using a gas chromatograph. The following main components were identified: CO, CO2, CH4, H2 and C2H4, C2H6, C3H6, C3H8. A significant impact of CaO on CO2 adsorption was found. The concentration of CO2 in syngas decreased with increased temperature, and the highest decrease occurred in the presence of CaO from above 60% to below 30% at 600 °C.