Gurhan Ertasgin

Dr. Gurhan Ertasgin

orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2006 in IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics
Verified
Conference Paper
Closed access
DWDavid Whaley
David Whaley
GEGurhan Ertasgin
Gurhan Ertasgin
WSWen L. Soong
Wen L. Soong
NENesimi Ertugrul
Nesimi Ertugrul
JDJames Darbyshire
James Darbyshire
CNChem V. Nayar
Chem V. Nayar
This paper describes a novel low-cost grid-connected inverter for small-scale wind turbines based on a high-inductance PM generator operating in a constant-current output mode. The PM generator is connected to a switched-mode rectifier (SMR) which consists of an uncontrolled rectifier and a switch. The combination of the high-inductance generator and uncontrolled rectifier produces a constant DC current. The switch is used to modulate this current and produces an output current whose fundamental component is a full-wave rectified sinewave and is in-phase with the grid voltage. A line-frequency commutated H-bridge inverter and LC output filter is used to produce a sinusoidal output grid current. The concept is verified using simulations and experimental results

29 May 2019 in Electronics
Verified
Journal Article
Open access
PDF file
GEGurhan Ertasgin
Gurhan Ertasgin
DWDavid Whaley
David Whaley
NENesimi Ertugrul
Nesimi Ertugrul
WSWen Soong
Wen Soong
Single-phase grid-connected photovoltaic (PV) inverters (GCI) are commonly used to feed power back to the utility. However, the inverter output power fluctuates at 100 Hz, which can be seen by the PV panel, and this reduces the PV output power. It is important to determine and analyze the correlation between the array voltage and current ripple and the average output power reduction of PV array. Therefore, this paper investigates the relationships between the oscillations due to single-phase switching and the DC link energy storage for PV GCIs. The balanced ripple definition is introduced and compared with the more common centered ripple definition. Some examples are provided that demonstrate the importance of these results, in the inverter design industry. The analysis presented here incorporates inductor trade-offs, which are verified with experimental results.

1 November 2008
Verified
Conference Paper
Closed access
GEGurhan Ertasgin
Gurhan Ertasgin
DWDavid Whaley
David Whaley
NEN. Ertugrul
N. Ertugrul
WSW. L. Soong
W. L. Soong
This paper investigates the performance of a 150 W single-phase current-source grid-connected inverter for PV cells. The constant-current source is realised using a DC link inductor and the inverter is implemented using a single boost switch, a H-bridge inverter and an LC output filter. Although the DC link inductor causes the inverter to be less efficient than an equivalent voltage-source inverter, it offers lower cost due to the zero-current switching and lower number of components. In addition, the output current is easily controlled using the boost switch and simple open-loop control. The inverter input is simulated using the dark I-V configuration of two PV cells. The advantage of this arrangement is the ability to conveniently simulate the PV cell over a wide range of irradiances. The entire system is implemented to verify the simulation results. Furthermore, the paper also examines the proposed inverterpsilas ability to deliver sinusoidal current to the grid whilst meeting the appropriate standards, i.e. total harmonic distortion and power factor requirements. Additionally, the inverterpsilas ability to maximise the PV cell and inverter output power is shown.

5 November 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
GEGurhan Ertasgin
Gurhan Ertasgin
DWDavid Whaley
David Whaley
In this study, the design of output low-pass capacitive–inductive (CL) filters is analyzed and optimized for current-source single-phase grid-connected photovoltaic (PV) inverters. Four different CL filter configurations with varying damping resistor placements are examined, evaluating performance concerning the output current’s total harmonic distortion (THD), the power factor (PF), and power losses. High-frequency harmonics are effectively attenuated by a second-order CL filter with the damping resistor placed parallel to the filter inductor. In addition, this filter type achieves the best performance by minimizing power loss. A systematic design methodology using filter normalization techniques allows to determine the optimum filter parameters based on the specified cut-off frequency (500 Hz), power loss (5% of rated power), and target THD (<5%). The analysis, simulations, and experiments show that under various operating conditions, this approach meets the grid connection standards (current THD < 5%, power factor between 0.8 leading and 0.95 lagging) while improving efficiency.

1 October 2018
Verified
Conference Paper
Closed access
EŞEralp Şener
Eralp Şener
GEGurhan Ertasgin
Gurhan Ertasgin
Three-phase grid-connected photovoltaic inverters are commonly used to feed power back to the utility. This paper aims to investigate a different DC-DC converter approach for photovoltaic applications which are connected to mains. The output of the PV array is connected to the Super-Lift Luo Converter (SLLC) to boost the system voltage significantly and a three-phase H-bridge inverter is used to produce sinusoidal output for grid connection. The principal aim of this paper is to provide an alternative PV inverter topology solution for medium scale (<;50 kW) applications as well as distributed grid-connected inverters. This paper will provide the operation principles of the proposed circuit and a range of computer simulation results.

29 July 2020 in Aircraft Engineering and Aerospace Technology
Verified
Journal Article
Closed access
ESEralp Sener
Eralp Sener
GEGurhan Ertasgin
Gurhan Ertasgin
Purpose: This paper aims to present an inverter with a current-source input for 400 Hz avionic systems to have a system which removes DC-link capacitors and presents a high efficiency. Design/methodology/approach: A battery-powered DC link inductor generates a constant-current source. A single high-frequency switch is used to provide a sinusoidally modulated current before the inverter. The output of the switch is “unfolded” by a thyristor-based H-bridge inverter to generate an AC output current. The system uses a CL low-pass filter to obtain a 400 Hz pure sine wave by removing pulse width modulation components. Findings: Simulations and Typhoon HIL real-time experiments were performed with closed-loop control to validate the proposed inverter concept while meeting the critical standards of MIL-STD-704F. Originality/value: This current source inverter topology is suitable for avionic systems that require 400 Hz output frequency. The topology uses small DC-link inductor and eliminates bulky capacitor which determines the inverter lifetime.