The paper reviews the recent works concerning the Portevin–Le Chatelier (PLC) effect in Advanced High-Strength Steels (AHSSs) with a special attention to high-strength medium-manganese steels. Theories explaining the mechanism of the plastic instability phenomenon in steels with medium- and high-Mn contents were discussed. The relationships between microstructural effects such as TRIP (Transformation-Induced Plasticity), TWIP (Twinning-Induced Plasticity) and the PLC effect were characterized. The effects of processing conditions including a deformation state (hot-rolled and cold-rolled) and strain parameters (deformation temperature, strain rate) were addressed. Factors affecting the value of critical strain for the activation of serrated flow behavior in particular in medium-manganese steels were described.

The work presents results on the effect of prior martensite formation on bainite transformation kinetics in a 3% medium-Mn multiphase steel. The material was subjected to two isothermal holding temperatures: 400 °C (without martensite) and 350 °C (with prior martensite). According to obtained dilatometric results, the formation of prior martensite leads to the acceleration of bainite transformation kinetics. The bainite formation starts and finishes much faster, when the prior martensite was present before the isothermal holding. The microstructural investigation of the steel after heat treatment was carried out using light and scanning electron microscopy. The microstructures were composed of fine bainitic laths with retained austenite and small amount of martensitic-austenitic islands at 400 °C. At 350 °C the presence of large tempered martensite laths was detected. The bainite is composed of a mixture of fine and coarse laths. The increase of the bainitic lath thickness is attributed to the coalescence process occurring at the lower holding temperature. The differences in the steel hardness after the two heat treatments were relatively small (~ 13 HV10).

This work presents insights into the manganese influence on the driving force and bainite transformation kinetics. Three different medium-Mn steels were subjected to theoretical calculations and dilatometric study in order to determine the Mn impact on bainite formation. The theoretical approach shows that the increase of manganese leads to a lower bainite fraction formed during the isothermal stage. This implicates the carbon enrichment of the austenite during thermal treatment. The less bainite is formed, the higher is the fraction of residual austenite which enrichment of carbon is globally low. Meanwhile, the manganese influences the incubation and transformation time. As the manganese content increases, the incubation period and formation time of bainite are longer because the chemical driving force essential to start and complete austenite into bainite transformation decreases. This was proved by theoretical calculations and dilatometric analysis, which show that even a small increase in manganese content leads to a longer time necessary to occur the bainitic transformation. For the steel containing 5% manganese, the driving force was too small that the transformation could occur even after 3 h. Additionally, the XRD analysis was conducted to determine the retained austenite fraction and its carbon enrichment. These results were compared with the theoretical values to determine the accuracy of the applied model.