Maraging steel is an engineering alloy which has been widely employed in metal additive manufacturing. This paper examines manufacturing and post-processing factors affecting the properties of maraging steel fabricated via laser powder bed fusion (L-PBF). It covers the review of published research findings on how powder quality feedstock, processing parameters, laser scan strategy, build orientation and heat treatment can influence the microstructure, density and porosity, defects and residual stresses developed on L-PBF maraging steel, with a focus on the maraging steel 300 alloy. This review offers an evaluation of the resulting mechanical properties of the as-built and heat-treated maraging steel 300, with a focus on anisotropic characteristics. Possible directions for further research are also identified.
This short communication offers a preliminary view on ongoing research conducted on the as-built EOS maraging steel 300. The material’s cyclic elastoplastic characteristics under strain-controlled loading have been investigated experimentally. Specimens fabricated under two primary orientations, horizontally and vertically to the build plate, have been tested. The obtained stress–strain hysteresis loops exhibited symmetry, with the vertical specimen showing a higher plastic strain energy dissipation capability than the horizontal specimen. Modelling of the material’s elastoplastic behaviour was performed with a commonly used kinematic hardening rule, combined with both isotropic and anisotropic yield functions and elasticity moduli. The obtained simulations of the hysteresis loops, from the implementation of these two plasticity models, indicate the advantage of the anisotropic modelling approach over the isotropic approach. The anisotropic plasticity model describes in a more representative way the inherent elastic and plastic anisotropy of the as-built material. Further research is underway to explore the low cycle fatigue performance of this additively manufactured metal.
This work concerns the use of profilometry‐based indentation plastometry (PIP) to obtain mechanical property information for maraging steel samples produced via an additive manufacturing route (laser powder bed fusion). Bars are produced in both “horizontal” (all material close to the build plate) and “vertical” (progressively increasing distance from the build plate) configurations. Samples are mechanically tested in both as‐built and age‐hardened conditions. Stress–strain curves from uniaxial testing (tensile and compressive) are compared with those from PIP testing. Tensile test data suggest significant anisotropy, with the horizontal direction harder than the vertical direction. However, systematic compressive tests, allowing curves to be obtained for both build and transverse directions in various locations, indicate that there is no anisotropy anywhere in these materials. This is consistent with electron backscattered diffraction results, indicating that there is no significant texture in these materials. It is also consistent with the outcomes of PIP testing, which can detect anisotropy with high sensitivity. Furthermore, both PIP testing and compression testing results indicate that the changing growth conditions at different distances from the build plate can lead to strength variations. It seems likely that what has previously been interpreted as anisotropy in the tensile response is in fact due to inhomogeneity of this type.
1 April 2018 in Materials Performance and Characterization
The residual stresses in heat-treated 7075 aluminum alloy blocks have been characterized using neutron diffraction, X-ray diffraction, and incremental center-hole drilling. Specimens were quenched to induce high-magnitude residual stresses, which were then stress relieved by the controlled application of plastic deformation using a cold compression technique. The experimental variables investigated were the quench water temperature and the postquench delay. This delay is considered to influence the final residual stress magnitudes because of hardening precipitation occurring by natural aging during the period between quenching and the application of plastic deformation. Cold compression significantly lowered the residual stresses in all specimens. Neutron diffraction measurements demonstrated a benefit to applying plastic deformation as soon as possible after quenching. However, this beneficial effect was not evident when characterizing surface residual stresses using hole drilling or X-ray diffraction.