Experimental findings obtained by FTIR and Raman spectroscopies on montmorillonite-water mixtures at three concentration values are presented. To get some insight into the hydrogen bond network of water within the montmorillonite network, FTIR and Raman spectra have been collected as a function of time and then analyzed following two complementary approaches: An analysis of the intramolecular OH stretching mode in the spectral range of 2700–3900 cm⁻¹ in terms of two Gaussian components, and an analysis of the same OH stretching mode by wavelet cross-correlation. The FTIR and Raman investigations have been carried as a function of time for a montmorillonite-water weight composition (wt%) of 20–80%, 25–75%, and 35–65%, until the dehydrated state where the samples appear as a homogeneous rigid layer of clay. In particular, for both the FTIR and Raman spectra, the decomposition of the OH stretching band into a “closed” and an “open” contribution and the spectral wavelet analysis allow us to extract quantitative information on the time behavior of the system water content. It emerges that, the total water contribution inside the montmorillonite structure decreases as a function of time. However, the relative weight of the ordered water contribution diminishes more rapidly while the relative weight of the disordered water contribution increases, indicating that a residual water content, characterized by a highly structural disorder, rests entrapped in the montmorillonite layer structure for a longer time. From the present study, it can be inferred that the montmorillonite dehydration process promotes the layer self-assembly.

The self-assembly process in a water solution of an amphiphilic polydimethylsiloxane-b-polyethyleneoxide (PDMS–PEO) diblock copolymer was investigated by means of small-angle X-ray scattering (SAXS) experiments in the concentration region below (and near) the critical micellar concentration (c.m.c. = 0.007 g cm⁻³). In the highly diluted region, at the copolymer concentration of c = 0.002 g cm⁻³, the early stage of the self-assembly process was characterized by the formation of small (primary) micellar units (with a radius of R = 2.7 nm) with core–shell morphology, which coexisted with larger supramolecular aggregates of entangled micelles (with an average radius of R = 9.5 nm). The increase in the copolymer concentration (to c = 0.005 and c = 0.01 g cm⁻³) caused increase in the sizes of both the small micelles and supra-micellar aggregates. Interestingly, at the concentration of c = 0.005 g cm⁻³, both the size and micelle aggregation number (N_agg) were found to increase on increasing the temperature in the range of 10 ≤ T ≤ 55 °C. This phenomenon was characterised by the dehydration process of the ethylene oxide (EO) segments, as evidenced by the calculation of excess water in the hydrophilic shell of the micelles. The more compact (less hydrated) structure of the hydrophilic PEO chains, which strongly influenced the spontaneous curvature of the amphiphile hydrophilic region, turned out to be the driving factor that favoured the increase in the micelle aggregation number with the increase in temperature. The obtained results evidence that the self-assembly process of PDMS–PEO copolymer amphiphiles is a gradual process that is already present at the very low concentration region (far below the macroscopically determined c.m.c.); moreover, it is characterised by a multi-stage organization process, where the primary building blocks self-assemble into more complex secondary structures that encompass multiple length scales.

Infrared spectra were collected on mixtures of ethylene glycol (EG) and polyethylene glycol 600 (PEG600) as a function of weight fraction from pure EG to pure PEG600. In this paper, it will be shown that while the OH vibrational contribution drastically reduces its center frequency from 3450 cm ⁻¹ to 3300 cm ⁻¹ in the weight fraction range 0–25%, the displacement of the mixture spectral features of the mixtures from ideal behavior, i.e., in the absence of interaction, shows the presence of a non-ideal mixing process. Furthermore, wavelet cross-correlation analysis of the registered pairs of spectra and of the intramolecular O–H stretching contributions reveals how the addition of a small amount of pure EG to PEG600 dramatically influences the structural properties of the polymeric matrix, owing to an increase the intermolecular connectivity. In particular, the wavelet cross-correlation parameters, evaluated between each pair of the registered data as a function of weight fraction, in a linear–logarithmic plot, reveals an inflection point for a weight fraction of about 25% of EG, which confirms that, within the three-dimensional networks of hydrogen-bonded EG-PEG600 molecules, a key role is played by EG in determining an increase in the hydrogen-bond network density.