Natural fiber-reinforced thermoplastic composites can be an alternative to mineral fiber-based composites, especially when economic and environment concerns are included under the material selection criteria. In recent years, the literature has shown how lignocellulosic fiber-reinforced composites can be used for a variety of applications. Nonetheless, the impact strength and the water uptake behavior of such materials have been seen as drawbacks. In this work, the impact strength and the water uptake of composites made of polypropylene reinforced with fibers from recycled newspaper have been researched. The results show how the impact strength decreases with the percentage of reinforcement in a similar manner to that of glass fiber-reinforced polypropylene composites as a result of adding a fragile phase to the material. It was found that the water uptake increased with the increasing percentages of lignocellulosic fibers due to the hydrophilic nature of such reinforcements. The diffusion behavior was found to be Fickian. A maleic anhydride was added as a coupling agent in order to increase the strength of the interface between the matrix and the reinforcements. It was found that the presence of such a coupling agent increased the impact strength of the composites and decreased the water uptake. Impact strengths of 21.3 kJ/m³ were obtained for a coupled composite with 30 wt % reinforcement contents, which is a value higher than that obtained for glass fiber-based materials. The obtained composites reinforced with recycled fibers showed competitive impact strength and water uptake behaviors in comparison with materials reinforced with raw lignocellulosic fibers. The article increases the knowledge on newspaper fiber-reinforced polyolefin composite properties, showing the competitiveness of waste-based materials.

The strength of the interphase between the reinforcements and the matrix has a major role in the mechanical properties of natural fiber reinforced polyolefin composites. The creation of strong interphases is hindered by the hydrophobic and hydrophilic natures of the matrix and the reinforcements, respectively. Adding coupling agents has been a common strategy to solve this problem. Nonetheless, a correct dosage of such coupling agents is important to, on the one hand guarantee strong interphases and high tensile strengths, and on the other hand ensure a full exploitation of the strengthening capabilities of the reinforcements. The paper proposes using topographic profile techniques to represent the effect of reinforcement and coupling agent contents of the strength of the interphase and the exploitation of the reinforcements. This representation allowed identifying the areas that are more or less sensitive to coupling agent content. The research also helped by finding that an excess of coupling agent had less impact than a lack of this component.

This article presents evidence of the convenience of implementing the geometric places of the plane into commercial computer-aided design (CAD) software as auxiliary tools in the computer-aided sketching process. Additionally, the research considers the possibility of adding several intuitive spatial geometric places to improve the efficiency of the three-dimensional geometric design. For demonstrative purposes, four examples are presented. A two-dimensional figure positioned on the flat face of an object shows the significant improvement over tools currently available in commercial CAD software, both vector and parametric: it is more intuitive and does not require the designer to execute as many operations. Two more complex three-dimensional examples are presented to show how the use of spatial geometric places, implemented as CAD software functions, would be an effective and highly intuitive tool. Using these functions produces auxiliary curved surfaces with points whose notable features are a significant innovation. A final example provided solves a geometric place problem using own software designed for this purpose. The proposal to incorporate geometric places into CAD software would lead to a significant improvement in the field of computational geometry. Consequently, the incorporation of geometric places into CAD software could increase technical-design productivity by eliminating some intermediate operations, such as symmetry, among others, and improving the geometry training of less skilled users.

No hay resúmenes disponibles. ECA Estudios Centroamericanos, Vol. 67, No. 728, 2012: 77-91.