In this paper we investigate the acceleration in relativistic jets of high-energy protons preaccelerated in the magnetosphere of a supermassive black hole. The proton reaches maximum energy when passing the total potential difference of between the jet axis and its periphery. This voltage is created by a rotating black hole and transmitted along magnetic field lines into the jet. It is shown that the trajectories of proton in the jet are divided into three groups: untrapped, trapped and not accelerated. Untrapped particles are not kept by poloidal and toroidal magnetic fields inside the jet, so they escape out the jet and their energy is equal to the maximum value, . Trapped protons are moving along the jet with oscillations in the radial direction. Their energy varies around the value of . In a strong magnetic field protons preaccelerated in the magnetosphere are pressed to the jet axis and practically are not accelerated in the jet. The work defines acceleration regimes for a range of the most well-known AGN objects with relativistic jets and for the microquasar SS433.
1 April 2017 in Radiophysics and Quantum Electronics
Centrifugal acceleration is due to the rotating poloidal magnetic field in the magnetosphere that creates the electric field which is orthogonal to the magnetic field. Charged particles with finite cyclotron radii can move along the electric field and receive energy. Centrifugal acceleration pushes particles to the periphery, where their azimuthal velocity reaches the speed of light. We calculated particle trajectories by numerical and analytical methods. The maximum obtained energies depend on the parameter of the particle magnetization κ, which is the ratio of rotation frequency of magnetic field lines in the magnetosphere ΩF to non-relativistic cyclotron frequency of particles ωc, κ = ΩF/ωc <<1, and on the parameter α which is the ratio of toroidal magnetic field BT to the poloidal one BP, α = BT/BP. It is shown that for small toroidal fields, α < κ1/4, the maximum Lorentz factor γm is only the square root of magnetization, γm = κ−1/2, while for large toroidal fields, α > κ1/4, the energy increases significantly, γm = κ−2/3. However, the maximum possible acceleration, γm = κ−1, is not achieved in the magnetosphere. For a number of active galactic nuclei, such as M87, maximum values of Lorentz factor for accelerated protons are found. Also, for special case of Sgr. A*, estimations of the maximum proton energy and its energy flux are obtained. They are in agreement with experimental data obtained by HESS Cherenkov telescope.
This study explores microcomposites’ thermodielectric properties—thermal conductivity () and dielectric permittivity ()—across filler concentrations from 1 wt% () to 60 wt% () spanning the pre- () and within-percolation threshold (). Thermal measurements were conducted using a newly designed, cost-effective thermal measurement setup. The setup utilised a transient heat pulse methodology with a heater and NTC thermistors, with a precision better than W·. Dielectric properties were measured using a three-electrode system over a broad frequency and temperature range. The measurements demonstrate an effective thermal conductivity of 0.72 W· for AlN at and 0.65 W· for wBN already at . Although theoretical models suggest that, considering interfacial Kapitza resistance, it can yield a corresponding to approximately 1–3% of the conductivity of pure material filler, the experimental measurements indicate a maximum of around 0.5%. Dielectric measurements show that in comparison to pure polyurethane, the presence of 60% AlN or 40% wBN at 60 °C decreased the loss tangent by 20 times in the condition of a quasistatic electric field.
The plasma temperature in a new plasma source shows unusual behaviour at low pressures (about 1 mTorr) and high absorbed powers. In Ar plasma at pressures of about 1 mTorr, the electron temperature shows a pronounced maximum inside an electromagnetic accelerator, which is followed by a rapid drop at the boundary between the accelerator region and the main chamber. In this paper a neoclassical thermo-conductivity model based on the analysis of the electron trajectories is proposed to describe the sharp electron temperature profile. Quantitative agreement of the calculated temperature profile with the experiment is observed.