Modular multilevel cascaded converter-based STATCOMs are scalable to higher voltages without requiring a step-up transformer with multiple windings and can be realized using a low switching frequency, giving lower harmonic content and hence a reduced filtering requirement. The paper presents a new injection technique to extend the operating ranges of MMCC STATCOMs when used for negative sequence and reactive current compensation. A non-sinusoidal voltage or current containing a fundamental and its third harmonic component is injected to achieve phase cluster voltage balance. This technique reduces the maximum dc-link voltage for the star configuration, and the maximum converter phase circulating current for the Delta case, compared to applying only sinusoidal zero sequence components for mitigating the same degree of load unbalance. The analysis is confirmed experimentally, showing that the third harmonic injection can allow a significant improvement of STATCOM capability for simultaneous compensation of unbalanced load and reactive curre

This paper presents a novel configuration of a unified power flow controller (UPFC) comprising a modular multilevel cascaded converter (MMCC) with a full-bridge inverter. The MMCC has one end of phase-legs shunt-connected to the transmission line. The other end connects in parallel to the primary terminals of a series line transformer, and the ac output terminals of a full-bridge dc-ac inverter. The submodules in the MMCC are full-bridge flying capacitor converters. This UPFC is compared to another type of MMCC-UPFC which uses double-star configuration, and submodules are of half-bridge chopper circuits; this is referred to as the Double Star Chopper Cells UPFC (DSCC-UPFC). The comparison is in terms of footprint, cost and performance. The new topology is lighter, more efficient and cheaper than the DSCC. Its operation principle and control scheme, which combines the regulations of voltage and of power flow along the transmission line are presented. Simulation studies for this new MMCC-UPFC realizing power flow control in a dual voltage sourced power network are presented and show good performance under varying operation conditions. The paper also evaluates the power control margins of this device.

The power-voltage (P-V) characteristic curves of a PV array are nonlinear and have multiple peaks under partially shaded conditions (PSCs). This paper proposes a novel maximum power point tracking (MPPT) method for a PV system with reduced steady-state oscillation based on a two-stage particle swarm optimization (PSO) algorithm. The grouping method of the shuffled frog leaping algorithm (SFLA) is incorporated in the basic PSO algorithm (PSO-SFLA), ensuring fast and accurate searching of the global extremum. An adaptive speed factor is also introduced into the improved PSO to further enhance its convergence speed. Test results show that the proposed method converges in less than half the time taken by the conventional PSO method, and the power is improved by 33% under the worst PSCs, which confirms the superiority of the proposed method over the standard PSO algorithm in terms of tracking speed and steady-state oscillations under different PSCs.

Carrier-based sinusoidal pulse-width modulation (PWM) techniques, such as phase disposoed PWM(PD-PWM) and phase shifted PWM (PS-PWM), are widely applied to control the modular multilevel cascaded converters (MMCC) having full H-bridge as sub-modules. This paper evaluates these PWM techniques when controlling a variant of the H-bridge MMCC, i.e. the MMCC five-level flying capacitor converter as sub-modules. This MMCC poses an extra challenge to PWM schemes; namely maintaining two inner floating capacitor voltage balancing. Two novel PWM techniques known as the swapped carrier PWM techniques are introduced for the control of this converter. The paper compares them with the two conventional ones using a performance metrics composed of voltage waveform performance, capability in natural flying capacitor voltage balancing, converter power loss, and switch utilisation. The results show that the proposed new PWM schemes outperform both conventional methods in both switching and conduction power losses and achieve similar performance like the PS-PWM under the three other metrics.