Emerging contaminants (ECs) are not monitored nor regulated consistently, but may have negative effects on human health and ecosystem balance. Although pharmaceuticals and personal care products are among the main ECs found in surface and wastewater, their toxicity and fate are currently not sufficiently studied. In this study, we analyzed for the first time a group of 46 ECs in the secondary effluent of the wastewater treatment plants (WWTP) of Prague. Thirty-seven compounds were identified in the discharge to surface water. Three compounds had no toxicology information on Artemia salina: furosemide, hydrochlorothiazide, and tramadol. We performed acute toxicity (LC50) tests and enzyme assays after 24 and 48 h at room temperature and 28 °C for these three compounds. LC50 ranged from 225.01 mg/L for furosemide, the most toxic, up to above 14,000 mg/L for tramadol. Changes in enzymatic activity for GST, GPx, AChE, and LDH when A. salina were exposed to LC25 for each contaminant were conspicuous and significant in a contaminant-, exposure time-, and temperature-dependent manner. These biochemical markers complement the toxicity profile of these contaminants in aquatic ecosystems and highlight the need for further research on other ECs and their implications, and the regulations required to protect human and ecological health.
This study evaluates the suitability of treated wastewater (TWW: secondary effluent and membrane effluent) for crop irrigation and the resultant impact on crop growth and soil physicochemical characteristics. Carrot seeds (Daucus carota subsp. sativus) were grown on loam soil and irrigated with tap water (Tap), secondary effluent (SE), and membrane effluent (ME) until maturity. Bacteriological analyses showed four log counts of E. coli and thermotolerant coliforms for secondary effluent, making it unsafe for the irrigation of carrots. Tap water and membrane effluent fulfilled the microbial limit for water reuse and were suitable for irrigation. The sodium absorption ratio, Kelly index, and magnesium hazard assessments indicated that all three irrigation water streams were suitable for irrigation. The average mass of carrot fruits for Tap, SE, and ME was 2.14 g, 3.96 g, and 3.03 g, respectively. A similar trend was observed for the dry matter composition: Tap had 15.9%, SE had 18.3%, and ME had 16.6%. The soil pH increased from 7.08 to 7.26, 7.39, and 7.33 for tap water-, secondary effluent-, and membrane effluent-irrigated soils, respectively. Nitrate-nitrogen and potassium levels increased in the TWW-irrigated soil, while that of the tap water-irrigated soil decreased. Sodium levels in the TWW-irrigated soil increased significantly but did not induce soil sodicity. The application of the TWW enhanced the growth of the carrot plants and increased the soil nutrient levels. Hence, using TWW in agricultural irrigation could promote food production and also limit the overdependency on freshwater resources. However, TWW should be disinfected by using UV disinfection and ozonation to reduce the risk of microbial contamination. Such disinfection methods may not lead to the formation of toxic byproducts, and therefore secondary pollution to crops is not anticipated.
The paper summarizes the development in the understanding and practical application of the activated sludge process over the last 50 years. Since its invention, the activated sludge process has been a big challenge to design engineers. Traditionally, the technology was covered by sanitary engineers. However, with the development in the understanding of activated sludge process principles, further progress was not possible without knowledge of reaction kinetics and reactor theory. The shift from BOD removal only to combined removal of organic pollution, nitrogen and phosphorus required a chemical engineering approach with outputs of activated sludge microbiology and microbial ecology. Molecular biology enabled more accurate identification of important activated sludge microorganisms. The development in activated sludge process also required more efficient activated sludge separation and thickening. The paper describes the development from secondary clarifiers to membrane separation. Increasing water stress around the globe has also changed the main wastewater paradigm from wastewater treatment and safe discharge to safe reuse.
Nitrification is the rate-limiting process in the design of activated sludge process. It is especially unstable during the winter season (when the temperature of activated sludge mixed liquor drops below 13 °C). It is therefore difficult to meet the ammonia effluent standards in winter. The common way to compensate for low nitrification rates at low temperatures is to increase sludge retention time (SRT). However, the increase of SRT is accompanied by negative factors such as elevated sludge concentration, higher sludge loading of secondary clarifiers, formation of unsettleable microflocs, etc. The low performance of nitrification at low temperatures can also be compensated for by enhancing the nitrification population in activated sludge. This paper describes such a method called bioaugmentation of nitrification in situ. This procedure takes place in a so-called regeneration tank, which is situated in the return activated sludge stream. The results of the operation of two wastewater treatment plants with regeneration zones are described in this paper, together with some economic evaluation of the bioaugmentation method.
The extent of activated sludge separation problems associated with excessive growth of filamentous microorganisms has increased recently in the Czech Republic. Most of the activated sludge plants in the country were contacted by mail with a questionnaire, the aim of which was to obtain the basic technological data on the plants and on the nature and intensity of activated sludge separation problems. Selected activated sludge plants were visited at different periods of the year and samples of activated sludge mixed liquor and foam were collected for microscopic examination and kinetic batch tests. It was found that good settling properties were associated more with good quality activated sludge flocs than with the absence of filaments. On the other hand, a very high abundance of filaments always resulted in bulking or foaming. The most common filamentous microorganisms in activated sludge mixed liquors were M. parvicella, N. limicola and Types 0092, 0041 and 0803 while the foams were mostly dominated by M. parvicella, NALOs (GALOs) and N. limicola. Seasonal shifts in filamentous population diversity were also observed. M. parvicella, Type 0092, N. limicola, Type 0803 and Type 0041 were dominant in both conventional and biological nutrient removal activated sludge plants whereas the other Eikelboom9s types of filaments dominated mostly in conventional activated sludge plants. The ability of foams to denitrify depended on the dominating filamentous microorganism and type of substrate.