As the roll-out of the fifth generation (5G) of mobile telecommunications is well underway, standardized methods to assess the human exposure to radiofrequency electromagnetic fields from 5G base station radios are needed in addition to existing numerical models and preliminary measurement studies. Challenges following the introduction of 5G New Radio (NR) include the utilization of new spectrum bands and the widespread use of technological advances such as Massive MIMO (Multiple-Input Multiple-Output) and beamforming. We propose a comprehensive and ready-to-use exposure assessment methodology for use with common spectrum analyzer equipment to measure or calculate in-situ the time-averaged instantaneous exposure and the theoretical maximum exposure from 5G NR base stations. Besides providing the correct method and equipment settings to capture the instantaneous exposure, the procedure also comprises a number of steps that involve the identification of the Synchronization Signal Block, which is the only 5G NR component that is transmitted periodically and at constant power, the assessment of the power density carried by its resources, and the subsequent extrapolation to the theoretical maximum exposure level. The procedure was validated on site for a 5G NR base station operating at 3.5 GHz, but it should be generally applicable to any 5G NR signal, i.e., as is for any sub-6 GHz signal and after adjustment of the proposed measurement settings for signals in the millimeter-wave range.

This paper describes the assessment of radiofrequency (RF) electromagnetic field (EMF) exposure from fifth generation (5G) new radio (NR) base stations in a commercial NR network in Bern, Switzerland. During the measurement campaign, four base station sites were investigated and the exposure induced by the NR massive multiple-input-multiple-output (MaMIMO) antennas was assessed at 22 positions, at distances from the base station between 30 m and 410 m. The NR base stations operated at 3.6 GHz and used codebook-based beamforming. While the actual field levels without inducing downlink traffic were very low (<0.05 V/m) due to a low traffic load and low antenna input powers of up to 8 W, setting up a maximum downlink traffic stream towards user equipment resulted in a time-averaged exposure level of up to 0.4 V/m, whereas the maximum extrapolated exposure level reached 0.6 V/m. Extrapolated to an antenna input power of 200 W, values of 4.3 V/m and 4.9 V/m, respectively, were obtained, which amount to 0.5–0.6% of the reference level recommended by the International Commission on Non-Ionizing Radiation Protection (ICNIRP). In Bern, it was found that the impact of the NR network on the total environmental RF exposure was very limited; with maximum downlink, it contributed 2% on average. Finally, it was also concluded that extrapolation to the maximum exposure level can be done without prior knowledge of the radiation patterns, directly based on the measurement of the Physical Downlink Shared Channel (PDSCH) resource elements.