The quantification of β-carotene in agricultural by-products is crucial for their valorization. However, commonly used analytical methods, such as UV–Vis spectrophotometry and high-performance liquid chromatography (HPLC), present critical differences in specificity and cost. This study compared β-carotene quantification using both methods, employing ethanol and hexane as extraction solvents, to determine β-carotene in peels from four mango varieties (Kent, Edward, Haden, and Criollo), following a 2×2×4 factorial design. Proximate analysis revealed significant differences in composition among the varieties. The results demonstrated a significant effect of the triple interaction (method × solvent × variety), indicating that all factors must be considered when selecting a β-carotene quantification protocol. Spectrophotometry systematically overestimated β-carotene content (up to 60% higher with ethanol) due to interference from other pigments. In contrast, HPLC provided specific quantification, revealing that hexane was significantly more efficient than ethanol for extraction. The Kent variety showed the highest β-carotene content. It is concluded that the HPLC–hexane combination is the optimal protocol for accurate quantification, whereas spectrophotometry provides only a useful screening estimate that should be interpreted with caution. The use of HPLC is recommended for studies requiring high accuracy, as well as for the validation of rapid methods against this standard for each new matrix.
El proceso de carbonización hidrotérmica ha llamado la atención de la comunidad académica y científica como una tecnología emergente y ecológica para la transformación de los residuos lignocelulósicos urbanos en fuente de bioenergía en forma sólida (hidrocarbón), líquida y gaseosa. Esta revisión aborda la comprensión de las propiedades y el potencial uso de estos residuos como fuente de bioenergía. Se analizan las propiedades fisicoquímicas y energéticas de estos residuos, así como los parámetros de operación que influyen en su transformación. Además, se presentan nuevas perspectivas sobre los desafíos futuros relacionados con el uso potencial de estos residuos y el proceso de carbonización. La conversión sostenible de estos residuos urbanos en una fuente de bioenergía contribuirá a reducir la dependencia de los combustibles fósiles, minimizar las emisiones de gases de efecto invernadero, garantizar una gestión eficiente de los residuos urbanos y desarrollar una bioeconomía circular.
Municipal sewage sludge contains carbon and mineral constituents that can be recovered as water-treatment materials. This study compared four silicon-rich carbons prepared under different carbon dioxide activation and nitric-acid modification conditions to examine whether material properties ranked arsenic(V) and lead(II) removal consistently. Pre-contact characterisation combined spectroscopy, microscopy, elemental analysis, nitrogen sorption and surface-charge assessment. Separate model-groundwater solutions containing each contaminant were treated in triplicate at pH 6.0, 6.5 and 7.0. Mean removal ranged from 47.8 to 76.2% for As(V) and from 68.8 to 96.3% for Pb(II). Two-factor analyses detected no significant material, pH or interaction effects at the 5% level. Averaged across the three pH levels, M3 had the highest numerical As(V) removal (71.7%), whereas M1 had the highest numerical Pb(II) removal (92.2%). A separate low-concentration test with M3 reported final concentrations of 0.0080 ± 0.0006 mg L−1 As(V) and 0.0041 ± 0.0004 mg L−1 Pb(II). Fifth-cycle removal remained above 80% for both contaminants, with 88.2% dry sorbent mass recovery after five cycles. The different material rankings indicate that total surface area alone does not describe performance across both contaminants. Further analytical, leaching and natural-water assessments are needed before application to drinking-water treatment.