Shell folded footings have drawn the interest of researchers for decades as an alternative to typical flat isolated footings because folded footings can reduce the needed amount of reinforced concrete in addition to enhancing the overall geotechnical performance of the supporting soil medium. The main setback of utilizing such folded footings is the relatively complex geometry of the bottom cavity, which requires proper compaction of the soil used to fill that cavity. Current geosynthetic materials such as geofoam or expanded polystyrene (EPS) proved efficiency in many geotechnical applications, where EPS was adopted herein as a cavity-filling material for folded footings. EPS and footing concrete properties were determined using the ultrasonic test device, such as modulus of elasticity and damping coefficient. The main aim of this study was to experimentally assess the behavior of folded footings with and without EPS filling using seven fully instrumented footing models with folding angles ranging from 0° to 45°. Reinforcement was placed in the footing models and limited along the perimeter to act as a hidden ring beam. The models were load tested inside a sandbox to measure internal stresses induced in the soil and the overall settlement. Results showed a significant enhancement in the soil behavior after using EPS. Modification factors were developed for the standard bearing capacity and settlement equations to account for the folding angle and EPS filling effects.
Magneto-rheological dampers (MR-Dampers) are increasingly being used in construction applications to reduce the dynamic response of structures to seismic activities or severe wind loading. Sensors attached to the structure will signal the computer to supply the dampers with an electric charge that transfers the MR fluid to a near-solid material with different physical and mechanical properties (viscoelastic behavior). Control algorithms govern the fluid to near-solid conversion, which controls the behavior of the damper and the performance of the structure under the seismic or wind loading event. The successful optimization of control parameters minimizes the overall structural response to dynamic forces. The main objective of this research is to change the output behavior of specific floors within a building subjected to seismic excitation by optimizing the MR-Damper control parameters to impact the behavior of a specific floor or number of floors within the building. The adjustment of control parameters to attain this objective was validated in multiple case studies throughout this research. The successful implementation of the research outcome will result in optimized MR-damper design to meet the performance-based criteria of building projects.