This study examined the effects and interactions of UV light dose (1,800 to 20,331 μJ/cm2) and apple cider pH (2.99 to 4.41) on the inactivation of Escherichia coli ATCC 25922, a surrogate for E. c...

This study examined the effect of different apple cultivars upon the UV inactivation of Escherichia coli O157:H7 strains within unfiltered apple cider. Apple cider was prepared from eight different apple cultivars, inoculated with approximately 10 ⁶ to 10 ⁷ CFU of three strains of E. coli O157:H7 per ml (933, ATCC 43889, and ATCC 43895), and exposed to 14 mJ of UV irradiation per cm ² . Bacterial populations for treated and untreated samples were then enumerated by using nonselective media. E. coli O157:H7 ATCC 43889 showed the most sensitivity to this disinfection process with an average 6.63-log reduction compared to an average log reduction of 5.93 for both strains 933 and ATCC 43895. The highest log reduction seen, 7.19, occurred for strain ATCC 43889 in Rome cider. The same cider produced the lowest log reductions: 5.33 and 5.25 for strains 933 and ATCC 43895, respectively. Among the apple cultivars, an average log reduction range of 5.78 (Red Delicious) to 6.74 (Empire) was observed, with two statistically significant (α ≤ 0.05) log reduction groups represented. Within the paired cultivar-strain analysis, five of eight ciders showed statistically significant (α ≤ 0.05) differences in at least two of the E. coli strains used. Comparison of log reductions among the E. coli strains to the cider parameters of °Brix, pH, and malic acid content failed to show any statistically significant relationship ( R ² ≥ 0.95). However, the results of this study indicate that regardless of the apple cultivar used, a minimum 5-log reduction is achieved for all of the strains of E. coli O157:H7 tested.

The aim of this study was to evaluate the influence of different concentrations of inulin and pectin as fat substitutes on the chemical composition, texture, and sensory acceptance of frankfurter sausages. Six treatments were evaluated to test fat replacement: control (T0); low fat control (T1); low fat with 15% inulin (T2); low fat with 30% inulin (T3); low fat with 7.5% inulin and 7.5% pectin (T4); and low fat with 15% inulin and 15% pectin (T5). The addition of fibers increased the yield (T3 and T5; 98.96%), and the color parameters were slightly reduced (T3). Moisture (61.14%) and ashes (6.96%) of sausages with inulin and pectin were higher (T5), while shear force, hardness, fracturability, gumminess, and chewiness (T3 and T5) were slightly lower than those of the control. The addition of inulin (T2) increased the sensory acceptance of the sausages (5.75). Fat can be replaced with inulin and pectin in frankfurter sausages to produce healthy and functional products.