This study examines concrete polishing waste (CFPW) potential as a partial cement substitute in mortar formulation. Concrete polishing waste, a by-product of the grinding and polishing of concrete surfaces, is mainly composed of fine particles of silica and calcium carbonate. The aim of the research was to assess this industry waste incorporation impact on various mortar properties. Four mixes containing different percentages of CFPW were tested for their physic-mechanical properties and environmental impact. The results show that increasing the CFPW percentage leads to higher porosity and shrinkage, as well as lower mechanical strength and density. However, a significant reduction in CO2 emissions was observed with CFPW incorporation (up to 29% reduction for 30% CPFW). Although CFPW use presents technical challenges, it offers an interesting opportunity to reduce mortars’ carbon footprint. The study concludes that moderate CFPW use can offer a balance between environmental benefits and performance, highlighting the need to optimize formulations to maximize benefits while minimizing compromises on mechanical properties.
In this study, new foam concretes incorporating hemp shives without the use of autoclaving have been developed and studied. Several protocols and parameters were investigated. Firstly, the influence of the addition of pozzolanic additives on the resulting density, mechanical behaviour and thermal conductivity was examined. Secondly, the effects of the incorporation of hemp shives at 5, 10 and 15 vol% on the previous three properties in such concretes were investigated. Moreover, economic cost and CO2 emissions were estimated to outline an optimized formulation of non-autoclaved biobased foam concretes. First, the target characteristics in terms of compressive strength (minimum of 2 MPa), thermal conductivity (less than 0.2 Wm−1K−1) and density (800 kg/m3) were achieved. It was noted that pozzolanic additions slightly improved the mechanical and thermal strength of non-autoclaved foamed concrete, while the addition of hemp shives improved the thermal strength but had an unfavourable effect on the mechanical strength. Moreover, both reduced the CO2 emissions.